Seagate ST19101N/W/WC/WD/DC manual WC/DC drives

Page 50

48	Cheetah 9 Installation Guide, Rev. B

WC/DC drives

Setting the SCSI ID jumpers

The SCSI ID for “WC” and “DC” model drives is normally set over the SCSI bus by the host system using connector contacts 39 (ID0), 40 (ID2), 79 (ID1), and 80 (ID3).

Terminating the drive

“WC” and “DC” model dr ives do not have internal terminators or any other way of adding internal termination to the drive. You must provide external termination to these drives when termina- tion is required.

Image 50

Contents ST19101N/W/WC/WD/DC Contents Preface Electrostatic discharge protection Important safety information and precautions Cheetah 9 Installation Guide, Rev. B Wichtige Sicherheitshinweise Cheetah 9 Installation Guide, Rev. B Page Electromagnetic compliance Regulatory agency complianceElectromagnetic susceptibility Electromagnetic compliance for the European Union Australian C-TickOnline services Seagate.comSeagate CompuServe forum FAX services SeaFAXDirect-support services Seagate technical supportCustomer service centers Manufacturer’s representativesGeneral description Drive characteristics Additional drive characteristics DC power requirements Amps ST19101 WC models WD, DC models +12V +5V Voltage regulation ± 5%Dimensions of the drive Drive models General informationScsi ID jumpers Drive termination Terminator power Circuits and data path widthsCable characteristics for single-ended circuits Pin I/O connection to drive Multiple drive connection to host adapter Multiple-drive connection to host adapter Scsi I/O Providing adequate cooling Kühlung des Systems Suggested air flow Abbildung 4. Empfohlener LuftstromverlaufMounting the drive and connecting cables Installation des Laufwerkes und Anschluß der KabelPage Pin Power Pin GleichstromHinweis Cheetah 9 Installation Guide, Rev. B Mounting configuration dimensions Formatting the drive Quick reference desktop system notesSetting the Scsi ID jumpers Setting the Scsi ID on model N drivesTerminating the drive Terminating the driveSetting terminator power jumpers Other applicable jumper options Additional jumper optionsWD drives Model W and WD drive alternate ID select and LED connection Terminating the drive W model shown Drive Front Other option jumpers are available as illustrated below WC/DC drives Applicable jumper options Jumper optionsDrive Active indicator Drive Active LED indicator connectionsPage Page