Planar PA1575R manual Start Your Installation, Remove the Back Cover

Start Your Installation

Remove the Back Cover

Please follow these instructions to remove the cover on the back panel of the LCD so that you can hookup the cables to associated connector.

Figure A

1.Remove the stand back cover by pulling in the direction of the arrow.

2.Connect applicable cables to the appropriate connectors.

3.Re-attach the stand back cover by pressing firmly until the tabs snap into place. You may also keep the cables in order by using the cable organizer.

! Note!

You can place the LCD flat horizontally to make it easier to connect the cables. Please make sure that you place it on an even surface lest the LCD should be damaged by scratches or collision.

included cables organizer

5