NAD L 70 Operation, Using the L70, Selecting Sources, Adjusting the Volume, Muting the Sound

Page 15

Operation

USING THE L70

You may operate the L70 DVD Surround Sound Receiver from its front panel or via the HTR L70 remote control. Since the remote will be the primary controller for most cases, we will focus on remote-controlled operations. Be sure also to read the section, “Front Panel” above.

SELECTING SOURCES

With the HTR L70’s remote’s “Amp” device selected, the remote’s numeric-key section directly selects the receiver’s internal DVD and tuner “TUNER”, as well as the other inputs and multichannel input (“Ext. 5.1”) refer to the orange labels directly above each key.

•When a source other than the internal DVD is selected, the video signal at the monitor output is always a black background, until the internal DVD is selected.

•When you change sources, the VFL will display the new input in its primary display.

ADJUSTING THE VOLUME

Use the HTR L70 remote’s <Volume up/down> keys to adjust the “master volume” of the L70, raising or lower all channels together.

NOTE

•A momentary keypress will change the master volume by 1 unit increments; if you hold down <Volume up/down> the master-volume change will “run-on” until the key is released.

•The L70’s OSD will show the volume setting as a line graphic with a numeric display above relative to the reference level.

Since recordings vary considerably in overall average level, there is no imperative to listen at any particular master-volume setting. A setting of 20 may sound “as loud” from one CD or DVD as 10 does from another.

•If muting has been activated (below), adjusting master-volume via the HTR L70 remote or the front- panel knob automatically releases the mute function.

•The L70 will power-up from standby mode at whatever master volume setting was last used; however, if the prior setting was greater than 50 the L70 will power up to 50. This prevents inadvertently beginning a session at excessive volume.

MUTING THE SOUND

Use the HTR L70 remote’s <Mute> key to silence all channels completely. Muting is always available, regardless of source or SURROUND MODE selections.

NOTE

•Cycling through standby or powering off releases muting; the L70 will return from standby with muting off if standby was invoked with muting on.

•A changing input or listening-mode selection releases muting.

•Adjusting the master-volume via the HTR L70 or the front-panel knob automatically releases the mute function.

SVENSKA PORTUGUÊS ITALIANO ESPAÑOL NEDERLANDS DEUTSCH FRANÇAIS ENGLISH

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents DVD Receiver Record Your Model Number NOW, While YOU can see IT Safety PrecautionsIntroduction This Product to Rain or MoistureTable of Contents Getting the Most from the NAD L70 Quickstart About the HTR L70 System Remote ControlEase of USE UpgradabilityFront Panel Identification of controlsJacks of the VCR Español Italiano Português Svenska Rear PanelImportant Note Dealing with HUM and Noise SetupSetting UP the L70 Getting StartedNavigating the OSD and Making Changes Setting L70 OSD Language Receiver Section onlyInput Setup Displaying the L70 RECEIVER’S OSDInput Selector Level Trim Test Setup Speaker ConfigurationSetting Speaker Configuration Surround ModeSetting Level Trim Delay TimeSetting Speaker Delay Time Selecting Sources Using the L70Adjusting the Volume OperationRegion Management Information Using the L70’S DVD/VCD/CDPress OPEN/CLOSE the Disc Tray Opens About DVD/SVCD/VCD/CDTV Display Disc Language Settings OSDOSD Navigation Video OSDOSD Language PasswordDefaults System OSDUsing the L70’S AM/FM Radio About User Names Choosing the FM Mute / ModeAbout RDS Viewing RDS TextStereo About the L70’S Surround ModesEars Enhanced StereoSelecting Surround Modes Dolby Digital / DTSEnhanced Stereo / Ears Delay Time Adjusting Surround ModesDTS Delay Time Dolby Digital Delay TimeAbout the 12 V Trigger OUT Adjusting Level Trim on the FLYTo Adjust Level Trim Adjusting the Tone ControlsUsing the HTR L70 Remote Control SpecificationsControlling the L70 PUNCH-THROUGH Cancel OperationLearning Codes from Other Remotes Example Learning VCR PauseRecording Macros Copy a Command from Another KEYMacro Commands KeyExecuting Macros KEY-ILLUMINATION TimeoutFactory Reset Delete ModeLoading CODE-LIBRARIES Search ModeMode Keys To Press for 3 seconds Checking CODE-LIBRARY NumberSummary of HTR L70 Modes Reference TroubleshootingTuner Section SpecificationsPhysical Specifications Amplifier SectionReference L70 Manual 03/05 China
Top Page Image Contents