Jwin JV-TV5020 user manual Other Keys, Troubleshooting

Page 2

JV-TV5020 USER’S MANUAL

USER’S MANUAL

CAUTION

RISK OF ELECTRIC SHOCK DO NOT OPEN

CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE, REFER FOR SERVICE TO QUALIFIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol, within an equatorial triangle, is intended to alert the user to the presence of un- insulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

THE GRAPHIC SYMBOLS WITH SUPPLEMENTAL MARKING IS APPLIED ON THE REAR SIDE OF THE SUBJECT MONITOR.

WARNING : To prevent fire or shock hazard, do not expose this appliance to rain, water, wet locations. Do not insert any metallic object through ventilation grilles.

MPORTANT SAFETY INSTRUCTIONS

This video monitor equipment is provided with a polarized alternating- current line plug (a plug having one blade wider than the other). This plug will fit into the power outlet only one way. This is a safety feature. If you are unable to insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact your electrician to replace your obsolete

8-CHANNEL QUAD SPLITTER

JV-TV5020

outlet. Do not defeat the safety purpose of the polarized plug.

6-2. Other Keys

FREEZE : Enables selected channel freezes in QUAD mode, FULL mode, MODE function.

1 ~ 8 : Enables selected channel be displayed in full screen.

ARROWS : Works only in the menu screen.

ENTER : An editing mode on the menu screen.

PAGE : PAGE A, PAGE B change function.

7.TROUBLESHOOTING

If the system does not function properly, check following points before contacting the service center.

No

Problem

Possible Solutions

 

 

 

 

 

Verify power to all pieces of equipment in

 

 

the system.

1

No Video

Verify that the power switches are in the

ON position.

 

 

 

 

Verify that the cameras are properly

 

 

hooked up.

 

 

 

2

Video,

Turn the power OFF for 30 seconds and

But no control

then turn it ON again.

 

 

 

 

8-CHANNEL QUAD SPLITTER

Image 2
Contents USER’S Manual Troubleshooting Other KeysFunction select keys Function Selection Keys Other KeysSection Purpose of this ProductSpecifications Connections 4 Buzzer MenuRear View Basic System Installation 2 Individual MenuInstallation with a VCR Connect all cameras to the splitter 1 General MenuMenu2 Mode key in Menu ModeMenu1 Menu5 Menu3Quad Mode Picture In Picture Mode 1PIP How to Program the Menus for OSD On-Screen DisplayChange Display Mode Auto key Channel key Any Mode Auto Sequence ModeQuad key Channel key Quad Mode Any Mode Auto Sequence Mode PIP Mode