Mounting Instruction

This Motorized Overhead Monitor requires a 12V DC power supply for the Monitor Display to open and close.

Please DO NOT OPEN and CLOSE BY HAND and handle it with care.

Please follow these steps carefully!

1Remove the transportation screw from the unit.

Transportation Screw

2Connect the main power connector (8-pin connector) as well as one of the AUX input, mini-DIN to RCA Interface connectors (refer to “Installation and Connections” on page 16). Also, refer to the same page showing 5m mini- DIN Extension Cable (to AUX-IN 1 connector) for further details. Make the proper Battery, ACC (ignition) and Ground connections to make the unit operational.

3-1 Turn the unit upside down. With both hands hold the edges of this unit so as not to interfere with the opening and closing the monitor. Open the monitor according to the following procedure. (Two persons may be needed.)

1)Press the OPEN/CLOSE button of this unit, or press the POWER button, press and hold the OPEN/CLOSE button of the supplied remote control for at least 2 seconds. The monitor will automatically open and close with each press.

NOTES

•Do not forcibly open or close the monitor. Doing so will cause damage.

•The monitor cannot be opened or closed unless the unit is turned upside down.

3-2 Use the supplied remote control to adjust the view angle of the monitor as required.

(See Page 6 “Adjusting the Monitor Viewing Angle”)

NOTE

Do not forcibly change the view angle of the monitor. Doing so may cause damage.

4After opening the monitor display and adjusting the viewing angle, move the battery line off before installing the unit.

5Use 4 screws and attach to the mounting plate.

(Screw holes are hidden under the panel. Therefore, the panel has to be opened.) (Two rear side screw holes are located under the mechanism cover plate.)

After installing the unit, reconnect the battery line which you moved off before.

Screws

Console

If you have any problem for the installation, please contact to ALPINE Tech Support.

15-EN