CAUTION
This symbol means important instructions. Failure to heed them can result in injury or material property damage.
HALT USE IMMEDIATELY IF A PROBLEM APPEARS.
Failure to do so may cause personal injury or damage to the product. Return it to your authorized Alpine dealer or the nearest Alpine Service Center for repairing.
KEEP FINGERS AWAY WHILE THE MOTORIZED FRONT PANEL OR MOVING MONITOR IS IN
MOTION.
Failure to do so may result in personal injury or damage to the product.
DO NOT MIX NEW BATTERIES WITH OLD
BATTERIES. INSERT WITH THE CORRECT BATTERY POLARITY.
When inserting the batteries, be sure to observe proper polarity (+ and
Rupture or chemical leakage from the battery may cause fire or personal injury.
PRECAUTIONS
Temperature
Be sure the temperature inside the vehicle is between
+45°C (+113°F) and 0°C (+32°F) before turning your unit on.
Fuse Replacement
When replacing the fuse(s), the replacement must be of |
| |||
the same amperage as shown on the fuse holder. If the |
| |||
| ||||
fuse(s) blows more than once, carefully check all |
| |||
electrical connections for shorted circuitry. Also have your | FR | |||
vehicle’s voltage regulator checked. | ||||
|
|
|
|
|
Maintenance |
|
|
|
|
If you have problems, do not attempt to repair the unit |
| |||
| ||||
yourself. Return it to your Alpine dealer or the nearest |
| |||
Alpine Service Station for servicing. |
| |||
|
|
|
|
|
Installation Location |
|
|
| ES |
Make sure the | ||||
• Direct sun and heat | • | Excessive dust |
| |
• High humidity | • | Excessive vibrations |
| |
•After turning the system off, a slight ghost of the image will remain temporarily. This is an effect peculiar to LCD technology and is normal.
•Under cold temperature conditions, the screen may
lose contrast temporarily. After a short | DE | |
period, it will return to normal. | ||
|
Dome Light Bulb Replacement Precautions
When replacing the dome light bulb, replace with one having the specified 12V, 5W capacity.
Use of a different capacity bulb may cause damage to the unit.
Note that damage under such circumstances will not be IT covered by the warranty.
To the customers using wireless headphones (sold
separately)
If you turn ACC or power source of the monitor off while you are listening with wireless headphones, a big noise occurs through the headphones. So, be sure to take
wireless headphones off your ears before you turn ACC or SE power source of the monitor off.
To the customers using wired headphones (sold
separately)
When you use the wired headphones with this unit, it is recommended to use the ones of impedance of 24 – 45 ohms.