Alpine TMX-R705 Adjusting the Monitor Viewing Angle, Adjusting the Volume, Audio Mute Function

Page 7

Basic Operations

Adjusting the Monitor Viewing Angle

Adjust the monitor's angle for better visibility.

1 While viewing the screen that is shown press the ANGLE 9 or 8 button to adjust the display to the ideal viewing angle.

The display viewing angle can be adjusted between about 80 and 105 degrees.

2 Press the 9or 9 button to adjust the right-left viewing angle. It is possible to adjust the display viewing angle up to about 15 degrees to the left or right.

Press and hold the OPEN/CLOSE button of the main unit for at least 2 second. This will return the monitor quickly to its center viewing position.

NOTES

• The angle changes continuously if the ANGLE 9 and 8 buttons or the 9and 9 buttons are held down.

If there are any obstructions to the monitor when adjusting the angle, first remove the obstruction and then readjust the angle.

The screen color will vary when viewed at certain angles. Adjust the screen angle for the best viewing position.

If the voltage of the vehicle's battery power is low, the screen may blink when the screen angle is changed. This is normal and not a malfunction.

The adjusted angle is stored in the memory.

Adjusting the Volume

1 Press the or button to adjust the volume.

NOTE

The volume changes continuously if the or button is held down. This operation will affect the headphone and External Audio outputs only. The IR signal for the wireless headphones are not affected.

Audio Mute Function

Activating this function will instantly lower the volume level by 20 dB.

1 Press the MUTE button to activate the MUTE mode. The audio level will decrease by about 20 dB.

Pressing the MUTE button again will bring the audio back to its previous level.

Switching the Source

1 Press the SOURCE button. Each press of the button will switch through the modes as follows:

AUX1 AUX2

NOTES

If nothing is connected to AUX 1 or AUX 2, raising the volume while these inputs are selected, may result in excessive noise.

In addition to the Remote Control Source button, each AUX input has its own wired select trigger. This is called the External AV Select (Pink/Blue) wire.

The External AV Select trigger is a pulsed signal (Active Low, 500ms or more). If this input is remains low, switching to other sources is not possible (Switching sources using the Remote Control is still possible). This is useful if you don’t want an AV source to be interrupted. Playing a video is a good example of this scenario. This function is mainly used for connecting with other ALPINE products.

6-EN

Image 7
Contents TMX-R705 Contents USE this Product for Mobile 12V Applications Minimize Display Viewing While DrivingHalt USE Immediately if a Problem Appears PrecautionsParts Names of the Overhead Monitor Basic OperationsClosing the Monitor Display Opening the Monitor DisplayAudio Mute Function Adjusting the Monitor Viewing AngleAdjusting the Volume Switching the SourceMode 1 Wide Switching Display ModesAdjusting Tint of Picture Adjusting Brightness of Picture Other Useful FeaturesSetting the Brightness of the Backlight Setting Automatic Closing Monitor Adjusting the Lowest Level of the BacklightDome Light Settings Replacing the Dome Light Bulb Battery ReplacementInformation SpecificationsCase of Difficulty Do not Install the Monitor Near the Passenger Seat AIR BAG Installation and ConnectionsPrecautions Mounting Instruction To other Monitor ConnectionsDoor SW PolarityLimited Warranty