I. PREPARATION OF VEHICLE INTERIOR
1.Remove the O.E.M. console mounted to inner roof of vehicle. Remove and discard dome light cover to gain access to (2) two #8 x 3/4" screws. Retain screws. Remove and retain (1) one #8 x 1 1/2" screw located in front of console near rear view mirror. See Figure 1.
FIGURE 1
2.Lower console and disconnect wiring at (2) two locations. Lay console on workbench for modification later.
See Figure 2.
FIGURE 3
FIGURE 2
3.Using rear edge of opening in headliner, carefully trim headliner as shown and install mounting bracket (item 5 pg 2). Make sure the 8” cut is centered in vehicle. Caution: Before cutting headliner material, check for wiring or other componentry above headliner. Cut only where indicated. Secure front of bracket to roof brace using (2) two O.E.M. screws, previously removed, in original locations. Make sure that bracket is centered in vehicle and secure rear of bracket to roof brace using (4) four #8 x 3/4" screws (item 1 pg 2). Install (2) two #8 x 3/4" screws (item 1 pg 2) in remaining holes next to O.E.M. screws previously installed.
See Figure 3.
3