FIGURE 7
8.Install the electronic compass in original position and secure using (2) two pieces of felt tape (item 7
pg 2). | See Figure 8. |
7.Mark a line on both sides of dome light as close to the edge as possible. Using a band saw or suitable tool, carefully trim console as shown. Discard dome light. Note: If console
is trimmed too far away from dome light, the trimmed edge may be visible when
installed in vinyl console. See Figure 7. Installer’s option: Turn console over and place on a padded surface. Trim console along ridge on either side of dome light.
FIGURE 8
5