18.Release video screen from locked position. Lower video screen to viewing position for access to mounting locations in top of video system
housing.
19.Raise video system into approximate position and connect all wiring to components. Route video cable through hole in mounting bracket. Connect wiring and cabling to video system per instructions included with video system.
20.Check function of all components and lights. See operating instructions for video system operations check. For further assistance, refer to the video system manual for the technical support phone number listed for your area.
21.Insert video system into opening in console.
Note: Make sure that wires do not get pinched between bosses on video system and console. Align holes in housing with clips in mounting bracket. Loosely install (4) four
Do not overtighten screws. See Figure 13.
22. Raise video screen into locked position.
FIGURE 13
23.Through the open compartment door on O.E.M. console, use an awl or similar tool to align holes in console with holes in bracket. Secure using (2) two #8 x 3/4" screws (item 2 pg 2). See Fig. 14. Close compartment door.
24.If console was equipped with a Homelinktm Transmitter, refer to the vehicle owner’s manual for reprogramming instructions.
FIGURE 14
8