FIGURE 9
10.Carefully turn console over and secure O.E.M. console using original screws. Start all screws before tightening. Caution: Do not overtighten screws. See Figure 10.
11.Install jumper wire harness (item 8 pg 2) to extend the red, violet, orange, and black wires previously cut on O.E.M. harness. Connect the white wires from video system light to orange O.E.M. wire. Connect the black wires from video system light to black O.E.M. wire. Firmly crimp wires then slide shrink sleeve over butt connector and apply heat.
6
9.Carefully insert modified console into vinyl covered console as shown. Insert the video system in the opening in center of console.
See Figure 9.Note: Leave
compartment door open to the 90 degree position until console is installed in vehicle. This will allow access for installing screws. If the door is closed prior to installation in vehicle, it will not open enough to properly install screws. CAUTION: The edges of O.E.M. console may be sharp and could cut the vinyl console during installation. It may be necessary to deburr the edge of console before installation.
FIGURE 10