Trim Ring Installation
The Trim Ring Installation is accomplished using the four (4) 2 X 8mm screws supplied. Please refer to the illustration below.
1.Place the VOD80 on a soft surface with the rubber gasket facing up. Use care to avoid scratching the unit’s exterior surface.
2.Place the trim ring on the unit and note the location of the four mounting screws.
3.Remove the four screws that are in the unit.
4.Remove the rubber gasket that is attached to the unit.
5.Attach the trim ring to the unit using the longer four (4) 2 X 8mm screws supplied.
6.Remove the four (4) rubber spacers from the bracket.
10