| 4. Mount push button. Use either screws or | |
| double sided tape to mount push button. | |
| To mount with screws, remove back of case by | |
| pushing in tab on bottom with a small screw- | |
| driver. | |
| Attach back of case to door jamb or wall. Snap front | |
| of push button on. | |
Figure 3 | When attaching push button using double sided | |
tape, make sure the surface of the door jamb or | ||
| ||
| wall is clean. |
5.Mount chime. There are two different ways to mount the chime depending upon the model of chime purchased. Determine which model you purchased below. Mount the chime according to the instructions for your chime.
Chime with sawtooth hanger attached to back:
1.Drill 1/4" diameter pilot hole for wall anchor (provided) and insert anchor.
2.Screw #8 screw (provided) into anchor. Leave 1/16" gap between screw head and wall.
3.Place hanger over screw to mount chime.
Sawtooth Hanger
Chime Volume
|
| 67 | 8 |
| 345 |
| |
12 |
|
| |
|
|
|
Jumpers
Figure 4