Blaupunkt RCM 104 operating instructions DSC programming

DSC programming

This car radio offers direct software control (DSC), which allows you to adapt a number of default settings to your preference and to store these values.

In the following you will find an overview of all the default settings adjusted at the factory. To change a programmed parameter,

•press DSC.

Then use the rocker switch and the -dBbutton to select and change the functions described below. The display shows the ad- justed status.

Select function

Change-Change-

settingsetting

Select function

CD NAME	Use this function to name
(only, if	your discs (see also CD
changer is	changer control, “Entering/
connected)	displaying CD names”)
ANGLE	Use one of the values -1, 0,
	or +1 to adapt the individual
	viewing angle.
	Adjust the ANGLE so as to
	provide the best view.
BEEP	Acknowledgement tone for
	all functions where the re-
	spective button has to be
	held down for more than 2
	seconds to activate the
	function.
	Adjust volume between 0
	and 9 (0 = OFF).

BRIGHT The display brightness can be adjusted between 1 and

16.You may set one day and one night adjust- ment.Brightness of night illumination:

Switch on the vehicle’s li- ghting system and program

the brightness value. For this, the lighting connector has to be connected to the electric system of the car.

COLOUR

(Variocolour) To gradually match the co- lours of the car radio and dashboard lighting to each other.

green ............. bright orange ............... red

CD DISP	During CD operation, use <<
(only, if	>> to select between the
changer is	following displays:
connected)	NAME –
	the name specified with CD
	NAME.
	TIME –
	the playback time of the title.
	NUMBER –
	disc and track number.
LED ON	You can select between LED
	ON and LED OFF. When
	setting LED ON, the Key-
	Card tongue will flash for
	optical theft protection when
	the set is switched off and
	the KeyCard removed.

32