Timer | Blaupunkt RCM 128 specification

TIME	The current time will be dis- TA VOL	To adjust the traffic an-
	played or has to be set. For	nouncement and warning
	more information see chap-	beep volume from between
	ter “Traffic Memo (TIM) -	0 to 63.
	Setting the clock in the DSC	The message will then come
	menu”.	through at this volume, if the
		standard volume is lower.
TIMER 1	To set the first TIM time.	Should the standard volume
TIMER 1	To set the first TIM time.	be higher than the TA VOL
	For more information please	be higher than the TA VOL
	For more information please	level, then the traffic report
	refer to chapter “Traffic	level, then the traffic report
	refer to chapter “Traffic	will be played slightly louder
	Memo (TIM) - Programming	will be played slightly louder
	Memo (TIM) - Programming	than the standard volume.
	the TIM standby mode / TIM	than the standard volume.
	the TIM standby mode / TIM
	times”.

Try out which SPEECH set- ting you like most.

BEEP Acknowledgement tone for all functions which require a button to be pressed for more than one second.

The volume can be adjusted from between 0 to 9. (0 = off).

ANGLE Use this setting to alter the viewing angle to your liking

TIMER 2 To set the second TIM time (procedure see TIMER 1).

CDC NAME Only available for CD chan- ger playback (optional). Use this function to name your CDs. (See “Entering CD names”).

LOUDNESS Loudness - When listening at a low level, the Loudness function creates a more nat- ural sound by boosting the low frequency range. LOUD 1 - Low boost LOUD 6 - Max. boost

SPEECH In future many RDS radio stations will differentiate be- tween music and speech programmes.

You can alter the tone for speech programmes from between “SPEECH 0 ... 4”.

SPEECH 0:

Music/speech off

SPEECH 1:

Linear reproduction (bass, treble and Loudness set to “0”)

SPEECH 2-4:

Different settings for vol- ume, bass and treble with the Loudness being switch- ed off.

from -1 to 0 to +1.

BRIGHT You can adjust the display brightness from between 1 to 16. You can also select different values for day and night.

Selecting the night bright- ness:

Switch on the vehicle lights and programme the bright- ness value. The car radio’s lighting connector must be hooked up to the vehicle’s electric system for this to function properly.