Blaupunkt RCM 128 operating instructions Quick reference, Fmt

Page 4

Quick reference

1Switching on/off with the ON button: Press ON.

When switching the set on with the ON button, the KeyCard has to be insert- ed. The unit will play with the pre- adjusted volume.

Switching on/off with the KeyCard: The set has to be turned on via the ON button.

Note:

Read the information in chapter “Key- Card theft protection system”.

Switching on/off via the ignition:

When connected correspondingly, the set can also be turned on and off via the vehicle ignition.

After the ignition has been switched off, a double beep tone will remind you that you should remove the KeyCard before leaving your vehicle.

Switching on with the ignition being switched off:

To keep on operating the set when the ignition is switched off (KeyCard is in- serted), proceed as follows:

Press ON after the double beep tone. The unit will be turned on.

To avoid that the battery goes flat, the system will be turned off automatically after a playback time of one hour.

2VOL+ / VOL-

To alter the volume.

Each time the set is switched on, it will play with the pre-adjusted volume (VOL FIX).

You may also change the VOL FIX set- ting (see chapter “DSC programming”).

3

For instantly muting the volume.

By pressing the button the volume will be muted immediately. “MUTE” will appear in the display.

The function is cancelled by pressing button or VOL+.

When pressing VOL-, the normal vol- ume will be by one grade lower than the mute volume.

To programme the mute volume level, proceed as follows:

Adjust the desired volume.

Press for two seconds until you hear a beep.

Now this volume level is stored as your mute volume.

Extra function

Memory button in the DSC menu.

4FMT

Press repeatedly to switch between the FM memory banks I, II and T (Tra- velstore).

When pressing this button, the system will automatically switch to FM.

Extra function FMT

To store the six most powerful stations automatically with Travelstore:

Press FMT until you hear a beep or “T-STORE” appears in the display.

5M•L - toggle switch

To toggle between medium and long wave reception.

DEUTSCH ENGLISH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS

33

Image 4
Contents Stockholm RCM Page Contents Quick reference FMTExtra rocker switch functions Rocker switchAUD J GEO DSC Mode H PTY Display Flashing KeyCard tongueMIX MIX CDMIX MAG MIX OFF2, 3, 4, 5, 6 preset buttons ? SRC source@ DIS Cassette loading slotAUD Extra function GEOImportant notes KeyCard theft protection system Removing the KeyCardReplacing a KeyCard Never pull out the KeyCard directlySwitching off the flashlight Short Additional Memory S.A.MTurn On Message T.O.M Optical indication for extra securityRadio operation with RDS Radio Data System Manual tuning with Scrolling through the broad- casting networks only FMChanging the memory bank FM Storing stationsTo start Preset Scan To select a scanned station and switchOff Preset Scan Changing the scan timeProgramme type Switching from stereo to mono FMNews Scanning stations with PTY-SCAN Storing programme typesPTY priority Receiving traffic programme stations with RDS-EON On/offAutomatic seek tuning start Adjusting GEO for traffic messages and the warning beepSwitching the warning beep off To make a settingSetting the clock in the DSC Traffic Memo TIMMenu Recalling stored traffic messagesProgramming the TIM standby mode / TIM times TIM standby mode while the radio is switched offDeactivating the TIM standby mode Tape operation Fast Forward/RewindInserting a tape Removing a tapeSwitching the tape side Scanning cassette titles withTions with Blank Skip Dolby B NRSwitching to CDC operation CD changer operation optionalCare notes Selecting CDs and titlesSelecting the display mode Storing the display modeMIX playback Scan operationDSC programming Deleting CD names withTimer TimeColour PTY LangScantime AUXSpecifications Overview of the DSC factory settingsAppendix Blaupunkt telephone hotline Blaupunkt-Werke GmbH