Blaupunkt RCM 128 Scrolling through the broad- casting networks only FM, Storing stations

Page 14

Seek tuning

Up Down

Down in short intervals (“AF” must be switched off) Up in short intervals (“AF” must be switched off)

Manual tuning with << >>

You can also tune in a station manually.

Condition:

AF and PTY must be switched off (i.e. the symbols do not light up in the display).

If necessary, deactivate these functions:

Press AF or PTY.

Manual tuning:

Press << >>; the frequency will change in short intervals in downwards or up- wards direction.

When holding the right or left part of the rock- er switch depressed, the frequency scan is speeded up.

Scrolling through the broad- casting networks (only FM)

You can use the << >> buttons to tune in stations of your reception area.

If several programmes of the broadcasting networks can be received, you can scroll through them in forwards direction pressing >>, or backwards using the << button, e.g. NDR 1, 2, 3, 4, N-JOY, FFN, ANTENNE ...

For this it is necessary that the stations have been tuned in at least once and that “AF” is active (lights up in the display).

For this purpose, you may start Travelstore seek operation:

Press FMT for two seconds; the sys- tem starts to run through the frequency band.

If “AF” does not light up,

press AF.

With this, the requirements for selecting sta- tions with << >> are fulfilled.

Changing the memory bank (FM)

You can shift between the memory banks I,

IIand T in order to store stations and recall them later.

The currently selected memory bank is in- dicated in the display.

Press the FMT button as many times until the desired memory bank lights up in the display.

Storing stations

On FM, you can store six stations on the preset buttons 1-6for each of the memory banks I, II and T.

On MW/LW, you can store six stations each.

Select the appropriate waveband with FMT or M•L.

Tune in a station with the rocker switch (either automatically / or manually << >>).

Press the desired preset button until the radio resumes play after the mu- ting (takes approximately two seconds, confirmed by beep).

Now the station has been stored.

The activated preset button is indicated in the display.

Notice:

Should you tune in a station which has al- ready been stored before on another memory bank, the corresponding preset but- ton and the memory bank will briefly flash in the display.

DEUTSCH ENGLISH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS

43

Image 14
Contents Stockholm RCM Page Contents Quick reference FMTAUD J GEO DSC Mode H PTY Rocker switchExtra rocker switch functions Display Flashing KeyCard tongueMIX MAG MIXMIX CD MIX OFF@ DIS 2, 3, 4, 5, 6 preset buttons? SRC source Cassette loading slotAUD Extra function GEOImportant notes Replacing a KeyCard KeyCard theft protection systemRemoving the KeyCard Never pull out the KeyCard directlyTurn On Message T.O.M Switching off the flashlightShort Additional Memory S.A.M Optical indication for extra securityRadio operation with RDS Radio Data System Changing the memory bank FM Manual tuning withScrolling through the broad- casting networks only FM Storing stationsOff Preset Scan To start Preset ScanTo select a scanned station and switch Changing the scan timeNews Switching from stereo to mono FMProgramme type PTY priority Storing programme typesScanning stations with PTY-SCAN Receiving traffic programme stations with RDS-EON On/offSwitching the warning beep off Automatic seek tuning startAdjusting GEO for traffic messages and the warning beep To make a settingMenu Setting the clock in the DSCTraffic Memo TIM Recalling stored traffic messagesDeactivating the TIM standby mode TIM standby mode while the radio is switched offProgramming the TIM standby mode / TIM times Inserting a tape Tape operationFast Forward/Rewind Removing a tapeTions with Blank Skip Switching the tape sideScanning cassette titles with Dolby B NRCare notes Switching to CDC operationCD changer operation optional Selecting CDs and titlesMIX playback Selecting the display modeStoring the display mode Scan operationDSC programming Deleting CD names withTimer TimeScantime ColourPTY Lang AUXAppendix Overview of the DSC factory settingsSpecifications Blaupunkt telephone hotline Blaupunkt-Werke GmbH