Blaupunkt RCM 128 Scanning cassette titles with, Tions with Blank Skip, Switching the tape side

of at least three seconds between the indi- vidual titles.

Scanning cassette titles with	Skipping unrecorded tape por-
SCAN	tions with Blank Skip

Switching the tape side		You can have the cassette titles played	This function senses an unrecorded tape
		briefly by using the scan function. If you like	portion continuing for more than 15 seconds
(autoreverse)		a title, stop the scan to continue listening to	and automatically fast forwards the cas-
To change the tape direction during casset-		that track.	sette to the beginning of the next track.
			During fast tape winding, “B-SKIP” will be
te playback:		To start/stop the scan function:
			indicated on the display panel.
• Press	.	• Press the SC button briefly.
			To switch the Blank Skip function on and
At the end of a tape side, the mechanism		You can individually adjust the scan time in
changes directions automatically to play the		the DSC menu (see “DSC programming - off:
other side (autoreverse). The display shows		SCANTIME”).	• Press the RM button for approximately
“TR1-PLAY” for track (side) 1 or “TR2-PLAY”			one second until you hear a beep.
for track 2.		Dolby B NR*	When the function has been activated, “BLS”
		With this unit you can play back tapes re-	will appear in the display.
Notice:
If there is too much tension on the tape		corded with Dolby-B NR or without noise	Listening to the radio during fast
		reduction.
during playback, the set may switch over by			tape winding with RM
		Cassette tapes recorded with Dolby NR*
itself before having reached the end of the			(Radio Monitor)
		stand out by their reduced tape hiss and the
tape side. In this case check the condition
		improved dynamics.	When the tape is fast forwarded or rewound
of the cassette tape. Sometimes it helps to
		If Dolby-B NR is switched on, “B” will light	(also with S-CPS), the radio will normally
rewind it completely.
		up in the display.	be muted. To listen to the radio during fast
Tape equalisation			winding, activate the Radio Monitor function.
		To switch on/off:	To switch RM on and off:
When a metal or CrO2 tape is inserted, the		• Press B (not during scan operation).	• Press RM.
tape mechanism automatically adjusts to .			When the function is active, “RM” will light
metal/CrO2 tape equalisation.		* Noise Reduction system manufactured under licen-	up in the display.
		se from Dolby Laboratories Licensing Corporation.
The “MTL” indicator will illuminate.		“Dolby” and the double-D symbol are trademarks of

Dolby Laboratories Licensing Corporation.

52