Blaupunkt RCR 45 operating instructions Short instructions, On Off Volume, Aud/Geo Aud

Page 4

Short instructions

1On Off Volume

This unit can also be switched on and off with the KeyCard B.

Also, when being connected correctly, you may turn the radio on and off via the ignition of your car.

Use one of the following possibilities to continue operating the set when the ignition is switched off:

a)Switch on/off with knob 1.

b)Remove/insert the KeyCard.

c)Press AUD 3.

When turning on the unit with the Key- Card or by pressing the AUD button, the system will start to play with the volume adjusted last.

When operating the unit with the igniti- on being switched off, the system will automatically shut down after one hour in order to avoid that the battery goes flat.

2LD

Loudness - When listening at a low level, the Loudness function creates a more natural sound by boosting the low frequency range.

To switch the Loudness on/off: Press LD.

For more information, read chapter “DSC programming”.

3AUD/GEO AUD –

To adjust the treble and bass frequen- cies with the rocker switch.

Treble +

Treble

Bass

Bass +

GEO –

To adjust the balance (left/right) and fader (front/rear) with the rocker switch.

Fader front

Fader rear

Balance left

Balance right

To alter a setting,

press AUD or GEO and then chan- ge the value with the rocker switch.

The adjusted value is indicated in the display.

The last setting will be stored automati- cally.

To finish the setting: Press AUD or GEO.

If the setting remains unchanged within 8 seconds, the display will switch back to the previous condition.

18

Image 4
Contents Verona RCR 1918 Contents Short instructions On Off VolumeAUD/GEO AUD REG Lo/dxDisplay Radio operation3, 4, 5, 6 preset buttons To switch overProg button/Fast winding = PSPrecautions Traffic safetyDSC mode Important notesInstallation/Connection KeyCard theft-protection systemPutting the unit into operation Removing the KeyCardOptical indication for extra security Displaying the radio pass dataAutomatic tuning Selecting a wavebandREG regional programme AF Alternative frequencyManual tuning Scrolling through the broad- casting network only FMChanging the memory bank FM Storing stationsSelecting the seek tuning sensi- tivity To start Preset ScanRecalling stored stations Scanning stations with Radio-ScanSwitching from stereo to mono FM Switching the warning beep offReceiving traffic programme stations with RDS-EON Traffic announcement priorityAutomatic seek tuning start Tape operationInserting a tape Removing a tapeDSC programming Prog selectorBeep LoudAppendix Overview of the DSC factory settingsCare notes Specifications AmplifierTuner Tape playerBlaupunkt-Werke GmbH
Related manuals
Manual 14 pages 34.35 Kb Manual 16 pages 42.15 Kb