| DSC programming | |
PROG selector | DSC (Direct Software Control) allows you to | |
(To change the tape direction during | customise certain programmable, basic set- | |
cassette playback) | tings to suit your personal needs and prefe- | |
• Press FR and FF simultaneously. | rences and then store them. | |
The basic settings for this audio equipment | ||
At the end of a tape side, the mechanism | ||
were made at the factory. In the following you | ||
changes directions automatically to play the | can find an overview of these settings, so that | |
other side (Autoreverse). The display shows | you can always reset to these if desired. |
PLAY” for track 2 or B. | • press DSC. |
|
BEEP | Confirmation tone for all |
| functions which require a |
| button to be pressed for |
| more than 2 seconds. |
| The volume can be adju- |
| sted from between 0 to 9. |
| (0 = off) |
| Each alteration of this va- |
| lue is confirmed by a beep |
| tone of the corresponding |
FRANÇAIS ENGLISH DEUTSCH
Notice:
If there is too much tension on the tape during playback, the set may switch over by itself before having reached the end of the tape side. In this case check the condition of the cassette tape. Sometimes it helps to rewind it completely.
The display will show you the adjusted con- dition.
Use the rocker switch to select and adjust the functions described in the following.
volume. |
LED (code) You can adjust the LED B |
to flash for extra |
protection. |
LED 1 - LED always flash- |
es when the unit |
has been swit- |
ched off via the |
ignition. |
ITALIANO NEDERLANDS
/ 
Select function
Adjust value –
Adjust value +
TA VOL To adjust the traffic an- nouncement volume from between 1 to 9. The mes- sage will then come through at this volume. (1 = low)
| LED 0 - No flashing. |
LOUD | Loudness - When listening |
| at a low level, the Loud- |
| ness function creates a |
more natural sound by boosting the low frequency range.
LOUD 1 - Low boost
LOUD 6 - Max. boost
SVENSKA ESPAÑOL PORTUGUÊS
29