CD/MP3/WMA/iPod mode
Changing to CD/MP3/WMA/iPod mode
Press the SRC button @repeatedly until the desired audio source is displayed:
•"CD": Inserted CD.
•"SD(HC)": Inserted memory card
•"USB FRONT" or "USB REAR": USB data carrier connected to the front or rear.
•"IPOD FRONT" or "IPOD REAR": iPod con- nected to the front or rear
•"AUX": Connected external audio source.
Notes:
•The respective audio source can be select- ed only if a corresponding CD is inserted or a corresponding device is connected.
•A connected iPod is initially selected un- der "USB" and, as soon as the iPod is recog- nised, under "IPOD".
•If the car sound system first has to read the data of a connected device or data car- rier before the playback, the display shows "READING". The duration of the reading depends on the data volume and design of the device or data carrier. If the device or data carrier is defective or the trans- ferred data cannot be played back, a corre- sponding message appears on the display (e.g. "CD ERROR").
Inserting/ejecting a CD
Inserting a CD
Risk of severe damage to the CD drive!
Noncircular contoured CDs (shape CDs) and CDs with a diameter of 8 cm (mini CDs) must not be used.
We accept no responsibility for any damage to the CD drive that may occur as a result of the use of unsuitable CDs.
Note:
You must not hinder or assist the drive as it automatically draws in the CD.
Insert the CD with its printed side up into the CD tray 5until you feel a slight resistance.
The drive automatically draws in the CD and checks its data. Afterwards, the playback starts in CD or MP3 mode.
Note:
If the inserted CD cannot be played back, "CD ERROR" is briefly displayed and the CD is au- tomatically ejected after approx. 2 seconds.
Ejecting a CD
Note:
You must not hinder or assist the drive as it ejects the CD.
Press the 
button 8 to eject an inserted CD.
Notes:
•If a CD is ejected and not removed, the drive will automatically draw it back in again after approx. 10 seconds.
•You can also eject CDs while the car sound system is switched off or whilst another au- dio source is activated.
Connecting/removing a USB data carrier
Note:
You can connect USB data carriers to the USB port at the front of the device as well as the rear USB port.
Connecting a USB data carrier
Switch off the car sound system so that the data carrier will be correctly registered.
First, pull the protective cap of the USB port :to the front until it moves out of the port and fold it to the right to connect a data car- rier to the USB port at the front of the device.
Connect the USB data carrier.
Turn on the car sound system.
11