Displays and controls

In the "Display -> Switch-on" menu item, you se- lect how the display will be switched on again.

If a call should be received after manual or auto- matic switch-off, the display switches on auto- matically again (provided that the radio is still switched on).

The OLED display shows different information de- pending on the current status of your BT-USB in- terface. Which control options are available via the green (left) and red right) phone button as well as the central rotary pushbutton is listed in the following sections.

Pressing the red and green phone button at the same time calls up the Settings menu. Here you can adjust many properties to your personal pref- erences, such as the language (English, French, German) or ID3 tags from MP3 ﬁles to be dis- played.

After initial switch-on

After switch-on, the OLED display greets you with a Blaupunkt lettering which gives way for a smaller lettering after a few seconds.

Registering (pairing) your cell phone with the interface

Use your cell phone to search for Bluetooth de- vices (see the instructions of the cell phone -> Pairing). The telephone ﬁnds "Blaupunkt IF" and asks for a PIN. Enter PIN 1234 on your cell phone. An existing BT handsfree connection is shown on your OLED display by a non-ﬂashing BT symbol in the top left corner.

If you telephone does not request a PIN, please check by means of the compatibility list for cell phones (www.blaupunkt.com) whether a differ- ent conﬁguration should be set for operation with your type of telephone.

You can couple up to 5 cell phones with the inter- face. If additional phones are coupled, the data of the phone coupled ﬁrst are deleted from the list.

The automatic reconnect for handsfree register- ing is started by the interface under the following conditions:

1.After switch-onof the interface, every one of the last up to 5 pairings is checked for up to 15 seconds whether a pairing can be re-established. During this time, the BT symbol ﬂashes. With active pairing, the BT symbol is displayed constantly. If no pairing is accomplished, the BT symbol goes out. As long as the BT symbol ﬂashes, acoustic interference's are possible in an existing audio stream connection, since all BT radio channels (including those in which an audio stream already exists) are checked for the pairing.

2.An automatic pairing attempt (ﬂashing BT symbol) starts if an existing pairing is dis- solved with switching off BT in the cell phone or removing it from the BT radio range.

3.Press on the green phone button (as long as no telephone is registered).ntaste (solange kein Telefon gekoppelt ist).

Note:

To initiate a pairing, it is NO LONGER required to hold the PTT button pressed for 5 seconds. The interface is always visible in the BT radio range and ready for pairing.

Without any preparation at the interface of your BT device, start the function "Find other BT de- vices" (may be called differently, see the in- structions of your BT device) and select your "Blaupunkt interface"