| Changing the display mode while | |||
ENGLISH | ||||
listening to an FM station | ||||
| ||||
| You can change the initial indication on the | |||
| display to station name (PS NAME) or station | |||
| frequency (FREQ) while listening to an FM RDS | |||
| station. |
|
| |
| • See also “Changing the general settings | |||
| (PSM)” on page 32. |
| ||
| 1 Press and hold SEL (select) for more than | |||
| 2 seconds so that one of the PSM items | |||
| appears on the display. |
| ||
| 2 Press ¢ | or 4 | to select “TU DISP” | |
| (tuner display). |
|
| |
3 Turn the control dial to set to the desired indication (“PS NAME” or “FREQ”).
4 Press SEL (select) to finish the setting.
Note:
By pressing DISP (display), you can change the display while listening to an FM RDS station. Each time you press the button, the following information appears on the display:
Station name
(PS NAME)
Station frequency
(FREQ)
Programme type (PTY)
•Then, the display goes back to the original indication in several seconds.
Setting the TA volume level
You can preset the volume level for TA Standby Reception. When a traffic programme is received, the volume level automatically changes to the preset level.
•See also “Changing the general settings (PSM)” on page 32.
1 Press and hold SEL (select) for more than
2 seconds so that one of the PSM items appears on the display.
2 Press ¢ 
or 4 
to select “TA VOL” (volume).
3 Turn the control dial to set to the desired volume.
You can set it from “VOL 00” to “VOL 50.”
4 Press SEL (select) to finish the setting.
Automatic clock adjustment
When shipped from the factory, the clock built in this unit is set to be readjusted automatically using the CT (Clock Time) data in the RDS signal.
If you do not want to use automatic clock adjustment, follow the procedure below.
•See also “Changing the general settings (PSM)” on page 32.
1 Press and hold SEL (select) for more than
2 seconds so that one of the PSM items appears on the display.
2 Press ¢ 
or 4 
to select “AUTO ADJ” (adjustment).
3 Turn the control dial counterclockwise to select “OFF.”
Now automatic clock adjustment is canceled.
4 Press SEL (select) to finish the setting.
To reactivate clock adjustment, repeat the same procedure and select “ON” in step 3 by turning the control dial clockwise.
Note:
You must stay tuned to the same station for more than 2 minutes after setting “AUTO ADJ” to “ON.” Otherwise, the clock time will not be adjusted. (This is because the unit takes up to 2 minutes to capture the CT data in the RDS signal.)
18