JVC Model KD-S580J manual Amplifier / Amplificador / Amplificateur

Page 27

PRECAUTIONS on power supply and speaker connections:

DO NOT connect the speaker leads of the power cord to the car battery; otherwise, the unit will be seriously damaged.

Connect the black lead (ground), yellow lead (to car battery, constant 12V), and red lead (to an accessory terminal) correctly.

BEFORE connecting the speaker leads of the power cord to the speakers, check the speaker wiring in your car.

If the speaker wiring in your car is as illustrated in Fig. 1 and Fig. 2 below, DO NOT connect the unit using that original speaker wiring. If you do, the unit will be seriously damaged. Redo the speaker wiring so that you can connect the unit to the speakers as illustrated in Fig. 3.

If the speaker wiring in your car is as illustrated in Fig. 3, you can connect the unit using the original speaker wiring in your car.

If you are not sure of the speaker wiring of your car, consult your car dealer.

PRECAUCIONES sobre las conexiones de la fuente de alimentación y de los altavoces:

NO conecte los conductores de altavoz del cable de alimentación a la batería de automóvil, pues podrían producirse graves daños en la unidad.

Conecte correctamente el conductor negro (a tierra), el conductor amarillo (a la batería del automóvil, 12V constantes), y el conductor rojo (a un terminal de accesorio).

ANTES de conectar a los altavoces los conductores de altavoz del cable de alimentación, verifique el conexionado de altavoz de su automóvil.

Si el conexionado de altavoz de su automóvil es como se indica en las Figs. 1 y 2 de abajo, NO conecte la unidad utilizando ese conexionado de altavoz original. Si lo hace, se producirán daños graves en la unidad.

Vuelva a efectuar el conexionado de altavoz de manera que pueda conectar la unidad a los altavoces de la manera indicada en la Fig.3.

Si el conexionado de altavoz de su automóvil es como se indica en la Fig.3, podrá conectar la unidad utilizando el conexionado de altavoz original de su automóvil.

Si tiene dudas sobre el conexionado de altavoz de su automóvil, consulte con su concesionario.

PRECAUTIONS sur l’alimentation et la connexion des enceintes:

NE CONNECTEZ PAS les fils d’enceintes du cordon d’alimentation à la batterie; sinon, l’appareil serait sérieusement endommagé.

Connectez correctement le fil noir (a la masse), le fil jaune (a la batterie de la voiture,12V constant) et le fil rouge (à la prise accessoire).

AVANT de connecter les fils d’enceintes du cordon d’alimentation aux enceintes, vérifiez le câblage des enceintes de votre voiture.

Si le câblage des enceintes de votre voiture est réalisé comme montré sur la Fig. 1 ou Fig. 2 ci-dessous, NE CONNECTEZ PAS l’appareil en utilisant ce câblage original d’enceintes. Si vous le faites, l’appareil sera sérieusement endommagé.

Recommencez le câblage des enceintes de façon que vous puissiez connecter l’appareil aux enceintes comme montré sur la Fig. 3.

Si le câblage des enceintes de votre voiture est comme montré sur la Fig. 3, vous pouvez connecter l’appareil en utilisant ce câblage original d’enceintes pour votre voiture.

Si vous n’êtes pas sûrs du câblage d’enceintes de votre voiture, consulter le concessionnaire de votre voiture.

+

+

+

L -

-

L -

+

+

+

R -

-

R -

+

 

 

-

+

+

 

 

L -

-

+

 

 

-

+

+

 

 

R -

-

Fig. 1

Fig. 2

Fig. 3

Connecting the leads / Conexión de los conductores / Raccordement des fils

Twist the core wires when connecting. Retuerza los alambres de alma para conectarlos.

Torsader les âmes des fils en les raccordant.

Solder the core wires to connect them securely. Suelde los alambres de alma para conectarlos con firmeza. Souder les âmes desfils pour les raccorder entre eux de façon sûre.

CAUTION / PRECAUCION / PRECAUTION:

To prevent short-circuit, cover the terminals of the UNUSED leads with insulating tape.

Para evitar cortocircuitos, cubra los cables NO UTILIZADOS con cinta aislante.

Pour éviter les court-circuits, couvrir les bornes des fils qui ne sont PAS utilisés avec de la bande isolante

BConnections Adding Other Equipment / Conexiones para añadir otros equipos / Raccordement pour ajouter d’autres appareils

You can connect an amplifier and other equipment to upgrade your car stereo system.

Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so that it can be controlled through this unit.

For amplifier only:

Connect this unit’s line-out terminals to the amplifier’s line-in terminals.

Disconnect the speakers from this unit, connect them to the amplifier. Leave the speaker leads of this unit unused. (Cover the terminals of the these unused leads with insulating tape, as illustrated above.)

Usted podrá conectar un amplificador y ostros equipos para mejorar el sistema estéreo de su automóvil.

Conecte el cable remoto (azul con rayas blancas) al cable remoto del otro equipo para que pueda ser controlado a través de esta unidad.

Sólo para el amplificador:

Conecte los terminales de salida de línea de esta unidad con los terminales de entrada de línea del amplificador.

Desconecte los altavoces de esta unidad y conéctelos al amplificador. Los cables de los altavoces de esta unidad quedan sin usar. (Cubra los terminales de estos cables sin usar con cinta aislante, tal comose indica en la figura de arriba).

Vous pouvez connecter un amplificateur ou autre appareil pour améliorer votre systéme autoradio.

Connecter le fil d'alimentation à distance (bleu avec des bandes blanches) au fil d'alimentation à distance de l'autre appareil de façon qu'il puisse être controlé par cet appareil.

Pour l'amplificateur seulement:

Raccorder les bornes de sortie ligne de cet appareil aux bornes d’entrée ligne de l’amplificateur.

Déconnectez les enceintes de cet appareil et connectez- les à l’amplificateur. Laissez les fils d’enceintes de cet appareil inutilisés. (Recouvrir les extrémités de ces fils inutilisés avec de la bande isolante comme montré ci- dessus.)

Amplifier / Amplificador / Amplificateur

Rear speakers Altavoces posteriores Haut-parleur arrière

Remote lead

Cable remoto

Fil d'alimentation à distance

Y-connector (not supplied with this unit) Conector en Y (no suministrado con esta unidad) Connecteur Y (non fourni avec cet appareil)

 

INPUT

JVC amplifier

L

L

Amplificador de JVC

 

 

R

R

Amplificateur JVC

Signal cord (not supplied with this unit)

Cable de señal (no suministrado con esta unidad) Cordon de signal (non fourni avec cet appareil)

 

LINE OUT

 

L

L

KD-S6250/S580

 

REAR

R

R

 

Front speakers

Altavoces delanteros

Blue with white stripe

Azul con rayas blancas

Bleu avec bande blancheTo automatic antenna if any

A la antena automática, si la hubiere

Vers l’antenne automatique, s’il y en a une

CAUTION / PRECAUCION / PRECAUTION:

To prevent internal heat builtup inside this unit, place this unit UNDER the other equipment.

Para evitar el aumento del calor interior de esta unidad, póngala DEBAJO del otro equipo.

Pour éviter un échauffement interne de cet appareil, placez-le SOUS l'autre appareil.

Haut-parleur avant

Image 27
Contents KD-S6250 KD-S580For customer Use How to reset your unit PrecautionsInformation For USA Contents Display window Location of the ButtonsControl panel Display windowOnly for KD-S6250 This section is only for KD-S6250 Remote controllerPlace the battery Installing the batteryRemove the battery holder Return the battery holderBasic Operations Turning on the powerTo drop the volume in a moment To turn off the powerSearching a station manually Manual search Radio Basic OperationsListening to the radio Searching a station automatically Auto searchWhen an FM stereo broadcast is hard to receive FM station automatic preset SSMStoring stations in memory Tune into a station of 88.3 MHz Tuning into a preset stationManual preset Select the number 1 6 for the preset station you wantInsert a disc into the loading slot CD OperationsPlaying a CD To stop play and eject the CDTo play back tracks at random Random Play Portion on a CDTo fast-forward or reverse the track To go to the next tracks or the previous tracksTo cancel the prohibition and unlock the CD Prohibiting CD ejectionPress and hold CD and 0for more than 2 seconds Select the item you want to adjust Sound AdjustmentsAdjusting the sound Adjust the levelRecalling the sound modes Select the sound mode you wantWhen SCM Link is set to Link ON, select the source For Preset values BasRepeat the same procedure to store other sound modes Storing your own sound adjustmentTo reset to the factory settings Call up the sound mode you want to adjustSetting the clock To Cancel Advanced SCMOther Main Functions Select Level if not shown on the display Select the desired mode VOLSelecting the level display VOL 2 or OFFHow to attach the control panel How to detach the control panelHandling CDs MaintenanceHow to handle CDs To keep CDs cleanSymptoms Causes Remedies TroubleshootingSpecifications FM TunerAM Tuner Call El fusible se quema Fuse blowsSound is distorted Unit becomes hotAsegúrese de conservar las manijas después de instalarlo Be sure to keep the handles after installing itBe sure to ground this unit to the car’s chassis NotaRemarque Amplifier / Amplificador / Amplificateur

Model KD-S580J specifications

The JVC Model KD-S580J is a highly regarded CD receiver that combines advanced technology with user-friendly features, making it an excellent choice for car audio enthusiasts. Known for its stylish design and exceptional sound quality, this model appeals to a wide range of drivers looking to enhance their in-vehicle entertainment experience.

One of the standout features of the KD-S580J is its compatibility with various audio formats. The unit supports CD, CD-R, and CD-RW playback, allowing users to enjoy their favorite music on different disc types. It also includes an auxiliary input, making it easy to connect external devices such as smartphones or MP3 players for seamless audio streaming. For added convenience, the receiver is equipped with a USB port, enabling users to access digital music files stored on USB drives.

The KD-S580J is designed with sound quality in mind, featuring a built-in 24-bit digital-to-analog converter (DAC) that delivers clear and dynamic audio reproduction. Additionally, it offers a customizable 3-band equalizer, allowing users to adjust the bass, midrange, and treble settings to suit their personal preferences. The unit also includes various sound enhancement technologies, such as JVC's “Sound Lift” feature, which helps to elevate soundstage for a more immersive listening experience.

User-friendliness is a key characteristic of the KD-S580J. The receiver features a large, easy-to-read display that stays illuminated for optimal visibility, even in low-light conditions. The intuitive interface allows for straightforward navigation through music libraries and settings, making it accessible for users of all levels.

Furthermore, the KD-S580J supports remote control functionality, allowing users to manage playback without taking their attention off the road. Its sleek design not only enhances the aesthetic of any vehicle interior but also ensures compatibility with various dashboard styles.

In conclusion, the JVC Model KD-S580J stands out in the competitive car audio market thanks to its combination of advanced playback capabilities, sound optimization features, and user-friendly design. Its versatility and performance make it an appealing option for anyone looking to upgrade their car audio experience.