JVC KD-SH55R, KD-SH77R manual Tuning into a preset station, Manual preset

	Manual preset
ENGLISH
	preset number 1 of the FM1 band
	You can preset up to 6 stations in each band
	(FM1, FM2, FM3 and AM) manually.
	Ex.: Storing an FM station of 88.3 MHz into the
	1 Select the band (FM1–3, AM) you
	want to store stations into (in this
	example, FM1).
		1 Press SOURCE
			repeatedly to select FM
			or AM as the source.
		2 If necessary, to select
			the FM band number,
			press and hold M/B
			(mode/band) for more
			than 1 second
			repeatedly. Each time
			you press and hold the
			button, the FM band
			changes as follows:
	FM 1		FM 2	FM 3

2 Tune into a station of 88.3 MHz.

Press ¢ to tune into stations of higher frequencies.

Press 4to tune into stations of lower frequencies.

3 Press and hold the number button (in this example, 1) for more than 2 seconds.

“P1” flashes for a while.

4 Repeat the above procedure to store other stations into other preset numbers.

10

Notes:

•A previously preset station is erased when a new station is stored in the same preset number.

•Preset stations are erased when the power supply to the memory circuit is interrupted (for example, during battery replacement). If this occurs, preset the stations again.

Tuning into a preset station

You can easily tune into a preset station. Remember that you must store stations first. If you have not stored them yet, see “Storing stations in memory” on page 9.

1 Select the FM or AM.

1 Press SOURCE repeatedly to select FM or AM as the source.

2If necessary, to select the FM band number,

press and hold M/B (mode/band) for more than 1 second repeatedly. Each time you press and hold the button, the FM band changes as follows:

FM 1FM 2FM 3

2 Select the number (1 – 6) for the preset station you want.

If the sound quality decreases and the stereo effect is lost while listening to an FM station

In some areas, adjacent stations may interfere with each other. If this interference occurs, this unit can automatically reduce this interference noise (the initial setting when shipped from the factory). However, in this case, the sound quality will be degraded and the stereo effect will be also lost.

If you do not want to degrade the sound quality and to lose the stereo effect, rather than to eliminate the interference noise, see “To change the FM tuner selectivity – IF FILTER” on page 26.