Manual preset
You can preset up to 6 stations in each band (FM1, FM2, FM3 and AM) manually.
Ex.: Storing an FM station of 88.3 MHz into the preset number 1 of the FM1 band
Notes:
•A previously preset station is erased when a new station is stored in the same preset number.
•Preset stations are erased when the power supply to the memory circuit is interrupted (for example, during battery replacement). If this occurs, preset the stations again.
ENGLISH
1 Select the band (FM1 – 3, AM) you want to store stations into (in this example, FM1).
Each time you press the
button, the FM band
changes as follows:
Tuning into a preset station
You can easily tune into a preset station. Remember that you must store stations first. If you have not stored them yet, see “Storing stations in memory” on page 6.
FM1 
FM2 
FM3 
AM
2 Tune into a station of 88.3 MHz.
Press ¢ 
to tune into stations of higher frequencies.
Press 4 
to tune into stations of lower frequencies.
3 Press and hold the number button (in this example, 1) for more than 2 seconds.
7
“P 1” flashes for a few seconds.
4 Repeat the above procedure to store other stations into other preset numbers.
1
2
Select the band (FM1 – 3, AM).
FM1 
FM2 
FM3 
AM
Select the number (1 – 6) for the preset station you want.
| 7 |
| 8 |
|
|
| 9 |
| 10 |
|
|
| 11 |
| 12 |
| ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
7