Kenwood TS-2000X Flow ON/ OFF, Frack, Hbaud, Kiss OFF ON/ OFF, Mcom OFF ON/ OFF, Mcon OFF ON/ OFF

21 APPENDIX

Command	Short	Default	Parameter	Description
Name
FLOW	F	ON	ON/ OFF	When ON, starting key entry causes the computer to stop
				displaying received packets.
FRACK	FR	3	0 ~ 250	Specifies the interval from one transmission until retry of
				transmission. The unit of the parameter is 1 second.
HBAUD	HB	1200	1200/ 9600	Selects 1200 or 9600 bps as the transfer rate between
				packet stations.
				Set the parameter ON, then switch the transceiver OFF.
				Turn the transceiver ON again to enter KISS mode. When
				the transceiver enters KISS mode, the “STA” and “CON”
KISS	KISS	OFF	ON/ OFF	LEDs blink alternatively a few times. To exit KISS mode,
				send the binary data C0 FF C0 to the TNC or turn the
				transceiver OFF. The next time you turn the transceiver
				ON, the TNC sets the parameter OFF automatically.
MCOM	MCOM	OFF	ON/ OFF	When ON, causes the TNC to also monitor control packets.
				When OFF, causes it to monitor only information packets.
MCON	MC	OFF	ON/ OFF	When ON, causes the TNC to monitor other stations while
				in connection with the target station.
MONITOR	M	ON	ON/ OFF	When ON, causes the TNC to monitor packets.
MRPT	MR	ON	ON/ OFF	When ON, causes the TNC to display the entire digipeat list
				for monitored packets.
			6
MYCALL	MY	NOCALL	characters	Specifies your call sign.
			+ SSID
PACLEN	P	128	0 ~ 255	Specifies the maximum length of the data portion of a
				packet.
			EVERY/	If set to EVERY, sends a packet at intervals of the specified
			AFTER n
PACTIME	PACT	AFTER 10		period (n). If set to AFTER, sends a packet only once after
			(n = 0 ~	the specified period (n). The unit of n is 100 milliseconds.
			250)
PERSIST	PE	128	0 ~ 255	Specifies a parameter to calculate probability for the
				PERSIST/SLOTTIME method.
PPERSIST	PP	ON	ON/ OFF	Causes the TNC to use the PERSIST/SLOTTIME method
				when ON, or the DWAIT method when OFF.
RESET	RESET	—	—	Restores the default status for all the commands.
RESPTIME	RES	5	0 ~ 250	Specifies the acknowledgment packet transmission delay.
				The unit of the parameter is 100 milliseconds.
RESTART	RESTART	—	—	Causes the TNC to function as if it is switched OFF then
				ON.
				Specifies the number of transmission retries. If packets are
RETRY	RE	10	0 ~ 15	not correctly accepted while in connection, a connect
				request is sent again after the specified number of retries.
SENDPAC	SE	$0D	0 ~ $7F	Specifies a character which forces a packet to be sent.

111