Kenwood TM-D700A, TM-D700E instruction manual MEMORY-TO-VFO Transfer, Channel Display

MEMORY-TO-VFO TRANSFER

You may sometimes want to search for other stations or a clear frequency, near the frequency stored in a memory channel or the Call channel. In this case first transfer the contents of a memory channel or the Call channel to the VFO.

1Recall the desired memory channel or the Call channel.

2Press [F], [MsV].

7• The entire contents of the memory channel or the Call channel are copied to the VFO.

Note:

◆A transmit frequency from an odd-split memory channel or odd-split Call channel is not transferred to the VFO. To transfer a transmit frequency, press [REV], then press [F], [MsV].

◆Lockout status and memory names are not copied from a memory channel to the VFO.

◆If you recall the Call channel in step 1, simply turning the Tuning Control or pressing Mic [UP]/ [DWN] also transfers the contents to the VFO. The frequency, however, is changed by one step.

CHANNEL DISPLAY

When in this mode, the transceiver displays only memory channel numbers (and memory names if stored) instead of frequencies.

1Press [MNU] to enter Menu mode.

2Press [c]/ [d] to select “RADIO (1–)”, then press [OK].

3Press [c]/ [d] to select “MEMORY (1–4–)”, then press [OK].

4Press [c]/ [d] to select “CHANNEL DISPLAY (1–4– 2)”, then press [OK].

5Press [c]/ [d] to switch the function ON (or OFF).

6Press [OK] to complete the setting.

7Press [MNU] to exit Menu mode.

Note: You cannot switch this function ON unless you can recall any channel on both bands A and B.

When in Channel Display mode, you cannot use the following functions:

Sub-band Select	VFO Select	VFO Scan
Memory Store	PM Store	PM Recall
Memory-to-VFO	Partial/ Full/ PM Reset	Frequency Step Size
Transfer		Change
1/ 10 MHz Step Change	All-control Lock

40