Kenwood TM-D700A, TM-D700E Programmable Function PF Keys, PF PF1, MR PF2, VFO PF3, Call PF4

PROGRAMMABLE FUNCTION (PF) KEYS

The Programmable Function keys are [PF], [MR], [VFO], and [CALL] located on the face of the microphone. These keys have the following default functions:

	[PF] (PF1)				Band Select
	[MR] (PF2)				Memory Recall
	[VFO] (PF3)				VFO Select
	[CALL] (PF4)			Call Channel Select
				(TM-D700E: 1750 Hz Tone TX)
	If you prefer, you can change the defaults to the
	following key functions:
	Key Function	Ref.	Key Function		Ref.	Key Function	Ref.
		Page			Page		Page
13	A/B	17		REV	33	STEP	64
	MONITOR	19		LOW	21	VISUAL	48
	ENTER	30,37,		MUTE	72	DIM	65
		56,63
	VOICE	83		CTRL	17	SUB-BAND SEL	17
	1750	32		PM IN	44	DX	(6)
	PM	44		A.B.C.	66	TNC	(4,6,11)
	MENU	22		MsV	40	LIST	(15)
	VFO	15		M. IN	36	P. MON	(26)
	MR	37		C. IN	39	BCON	(25,32)
	CALL	39		LOCK	67	MSG	(30 ~ 32)
	MHz	20		T. SEL	30,55,57	POS	(19,20)
	TONE	30,55,57		SHIFT	29	PWR	19
						(PF1only)

For the shaded functions, see the separate manual,

“SPECIALIZED COMMUNICATIONS”.

1Press [MNU] to enter Menu mode.

2Press [c]/ [d] to select “RADIO (1–)”, then press [OK].

3Press [c]/ [d] to select “MIC (1–8–)”, then press [OK].

4Press [c]/ [d] to select “PF1 (1–8–1)” to “PF4 (1–8–4)”, then press [OK].

5Press [c]/ [d] to select the desired function.

6Press [OK] to complete the setting.

7Press [MNU] to exit Menu mode.

After switching the power OFF, you may press Mic [PF]+ POWER ON. This allows you to skip steps 1 to 4. Press Mic [MR], [VFO], or [CALL] instead of [PF] as necessary.

Note:

◆Without an optional VS-3 unit installed or with OFF selected in Menu 1–2–4 (VOICE), pressing the PF key programmed with Voice causes the transceiver to announce the current frequency using beeps of different frequencies.

◆To restore the default functions, perform Full Reset {page 41}.

62