Para cumplimiento de Ia Cofetel | Kenwood KDC-X597 specification

CAUTION

Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.

In compliance with Federal Regulations, following are reproductions of labels on, or inside the product relating to laser product safety.

JVC KENWOOD Corporation 2967-3,ISHIKAWA-MACHI, HACHIOJI-SHI, TOKYO, JAPAN

THIS PRODUCT COMPLIES WITH DHHS RULES 21 CFR SUBCHAPTER J IN EFFECT AT DATE OF MANUFAGURE.

Location :Top Plate

FCC WARNING

This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmfvl interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made.

FCC NOTE

This equipment has been tested and found to comply with thelimits for aClass B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in aresidential installation. This equipment may cause harmful interference to radio communications, if it is not installed and used in accordance with the instructions. However, there is no guarantee that interference will not occur in aparticular installation.lf this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on acircuit different from that to which the ' receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

•"Made for iPod," and "Made for iPhone" mean that an electronic accessory has been designed to connect specifically to iPod, or iPhone, respectively, and has been certified by the developer to meet Apple performance standards. Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards. Please note that the use of this accessory with iPod or iPhone may affect wireless performance.

•iPhone, iPod, iPod classic, iPod nano, and iPod touch are trademarks of Apple Inc., registered in the U.S. and other countries.

•Pandora, the Pandora logo, and the Pandora trade dress are trademarks or registered trademarks of Pandora Media, Inc., used with permission.

•The"AAC" logo is atrademark of Dolby Laboratories.

•Android is trademark of Google Inc.

•The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by JVC KENWOOD Corporation is under license. Other trademarks and trade names are those of their respective owners.

Informacion acerca de Ia eliminacion de equipos eh!ctricos yelectronicos al final de Ia vida util (aplicable alos paises que hayan adoptado sistemas independientes de recogida de residuos)

Los productos con el slmbolo de un contenedor con ruedas tachado no pod ran ser desechados como residuos domesticos. Los equipos electricos yelectr6nicos al final de Ia vida utiI, deberan ser reciclados en instalaciones que puedan dar el tratamiento adecuado aestos productos yasus subproductos residuales correspondientes. P6ngase en contacto con su administraci6n local para obtener informacion sobre el punto de recogida mas cercano. Un tratamiento correcto del reciclaje yIa eliminaci6n de residuos ayuda aconservar los recursos yevita al mismo tiempo efectos perjudiciales en Ia salud yel medio ambiente.

Para cumplimiento de Ia COFETEL:

"La operaci6n de este equipo esta sujeta alas siguientes dos condiciones:

(1)es posible que este equipo odispositivo no cause interferencia perjudicial y

(2)este equipo odispositivo debe aceptar cualquier interferencia, incluyendo Ia que pueda causar su operaci6n no deseada"

IC (Industry Canada) Notice

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:

(1)This device may not cause interference, and

(2)this device must accept any interference, including interference that may cause

undesired operation of the device.

The term "IC: "before the certification/ registration number only signifies that the Industry Canada technical specification were met.

Note de IC (lndustrie Canada)

Le present appareil est conforme aux CNR d'lndustrieCanada applicables aux appareils radio exempts de licence.

L'exploitationest autorisee aux deux conditions suivantes:

(1)l'appareilne doit pas produire de brouillage, et

(2)l'utilisateurde l'appareildoit accepter tout brouillage radioelectrique subi, meme si

le brouillage est susceptible d'encompromettre le fonctionnement. L'expression"IC:" avant le numero d'homologation/enregistrement signifie seulement que les specifications techniques d'lndustrieCanada ont ete respectees.

CAUTION

This equipment complies with FCC/I( radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines in Supplement Cto OET65 and RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment has very low levels of RF energy that it deemed to comply without maximum permissive exposure evaluation (MPE). But it is desirable that it should be installed and operated keeping the radiator at least 20cm or more away from person'sbody (excluding extremities: hands, wrists, feet and ankles). Under Industry Canada regulations, this radio transmitter may only operate using an antenna of atype and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.

ATTENTION

Cet equipement est conforme aux limites d'expositionaux rayonnements enoncees pour un environnement non contr61e et respecte les regles d'exposition aux frequences radioelectriques (RF) CNR-102 de I'IC.Cet equipement emet une energie RF tres faible qui est consideree conforme sans evaluation de !'expositionmaximale autorisee. Cependant, cet equipement doit etre installe et utilise en gardant une distance de 20 em ou plus entre le dispositif rayonnant et le corps (a I'exception des extremites: mains, poignets, pieds et chevilles). Conformement aIa reg Iem entation d'lndustrieCanada, le present emetteur radio peut fonctionner avec une antenne d'untype et d'ungain maximal (ou inferieur) approuve pour l'emetteurpar lndustrie Canada. Dans le but de reduire les risques de brouillage radioelectrique a!'intentiondes autres utilisateurs, il faut choisir le type d'antenneet son gain de sorte que Ia puissance isotrope rayon nee equivalente (p.i.r.e.) ne depasse pas l'intensitenecessaire al'etablissementd'unecommunication satisfaisante.

•Contains Bluetooth Module FCC ID: XQN-BTR60X

•Contains Bluetooth Module IC: 9688A-BTR601