Initial System Start-Up
Be sure to press the RESET switch when using the unit for the first time, after changing the car battery, etc.
1Turn off the unit power.
2Press y(OPEN) to open the front panel, and then remove it.
3Press RESET with a ballpoint pen or similar pointed object.
RESET switch
Adjusting Volume
Turn the Rotary encoder until the desired sound is obtained.
Lowering Volume Quickly
Activating the Audio Mute function will instantly lower the volume level by 20 dB.
1Press MUTE to activate the MUTE mode. The audio level will decrease by about 20 dB.
2Pressing MUTE again will bring the audio back to its previous level.
Setting the Time and Calendar
1Press and hold AUDIO/SETUP for at least 2 seconds to activate the SETUP selection mode.
2Turn the Rotary encoder to select the General mode, and then press ENTER.
3Turn the Rotary encoder to select Clock Adjust, and then press ENTER.
4Turn the Rotary encoder to set year.
5Press ENTER.
6Repeat steps 4 and 5 above to set month, date, hour and minute.
7Press and hold AUDIO/SETUP for at least 2 seconds to return to normal mode.
Notes
•Pressing r returns to the previous SETUP mode.
•If no operation is performed for 60 seconds, SETUP is canceled.
•To synchronise the clock to another clock/watch or radio time announcement, press and hold ENTER for at least 2 seconds after setting the “hour”. Minutes will reset to 00. If the display shows over “30” minutes when you do this, the time will advance one hour.
Controllable with Remote Control
This unit can be controlled with an optional Alpine remote control. For details, consult your Alpine dealer. Point the optional remote control transmitter at the
Remote control sensor
Connectable to Remote Control Interface Box
With an optional Alpine Steering Wheel Remote Control Interface Box, this unit is controllable from the vehicles steering wheel controls. For details, contact your Alpine dealer.