Displaying the Regional Label
The regional name of the ensemble that you are listening is displayed.
1 Press TITLE for at least 3 seconds.
“REGIONAL” is displayed for two seconds, and then the Regional Label is displayed for 5 seconds, and then you return to the display that you selected with the steps described under the section “Changing the Display Mode” on page 31.
•If no Regional Label is received, “NO REGON” is displayed.
•When you are in the Dynamic Label mode, you cannot display the Regional Label.
Receiving Announcement Information of DAB Local Stations
1 Press F/SETUP for at least 3 seconds.
2 Press g or f to select “DAB REG” (“REG”).
3 Press BAND/TEL. to select ON or OFF for DAB REG.
ON: You can automatically receive announcement interruptions that are valid for the region you are currently in.
OFF: Announcement interruptions are valid for all regions.
4 Press F/SETUP to return to the normal mode.
Setting for Automatic Change from DAB to
RDS
When the DAB reception is poor, you can set this selection ON to automatically change to the RDS station (a station that can be received) within the same broadcasting station until good reception is achieved. You can switch this for voice only (except Service label/ Dynamic label display). The display and operation remain as for DAB.
1 Press F/SETUP for at least 3 seconds.
2 Press g or f to select “R/D SW.”
3 Press BAND/TEL. to select either ON or OFF.
4 Press F/SETUP to return to the normal mode.
•When reception is being changed from DAB to RDS, the DAB indicator blinks.
Setting ON/OFF for DRC (Dynamic Range Control)
If you set this ON when receiving the sound of a wide Dynamic Range, the DRC (Dynamic Range Control) gain increases when the source sound is small, and the DRC (Dynamic Range Control) gain decreases when the source sound is large, making the Dynamic Range narrower to give you better and more comfortable sound even in the vehicle that produces a large noise.
1 Press F/SETUP for at least 3 seconds.
2 Press g or f select “DAB DRC” (“DRC”).
3 Press BAND/TEL. to select either ON or OFF.
4 Press F/SETUP to return to the normal mode.
•When a radio programme is set to ON, sound other than what you previously set may be produced depending on the broadcast. In this case, turn the programme OFF.