Getting Started
(OPEN)
MUTE SOURCE/POWER
Rotary | MODE | TITLE |
encoder |
|
|
About the alphanumeric display of this unit
•All English lower case characters are displayed as upper case on this unit.
•The alphanumeric display in the following table shows alphanumeric characters/numbers that may be difficult to distinguish.
Alphanumeric
Display
Alphanumeric
Display
Turning Power On and Off
Press SOURCE/POWER to turn on the unit.
•The unit can be turned on by pressing any other button except TITLE,
Rotary encoder and 
(OPEN).
Press and hold SOURCE/POWER for at least 2 seconds to turn off the unit.
•The first time power is turned on, the volume will start from level 12.
Detaching and Attaching the Front Panel
Be sure to push the Rotary encoder inside the unit before opening the front panel so that the front panel will open completely, otherwise it may be damaged.
Push the Rotary encoder inside
When you push the Rotary encoder again, it pops back out.
The Rotary encoder pops out
Detaching
1Turn off the unit power.
2Press 
(OPEN) to open the front panel.
To close the front panel, press the left side until it locks as shown in the figure below.
3Grasp the front panel firmly, slide to the left 
,
then pull 
to remove.
•The front panel may become hot in normal usage (especially the connector terminals on the back of the front panel.) This is not a malfunction.
•To protect the front panel, place it in the supplied carrying case.
•When detaching the front panel, do not apply excessive force as it may result in malfunction.
•Do not leave the front panel open, or drive the car with the panel open as it may result in accident or malfunction.
Attaching
1Insert the right side of the front panel into the main unit. Align the groove on the front panel with the projections on the main unit.
2Push the left side of the front panel until it locks firmly into the main unit.
•Before attaching the front panel, make sure that there is no dirt or dust on the connector terminals and no foreign object between the front panel and the main unit.
•Attach the front panel carefully, holding the sides of the front panel to avoid pushing buttons by mistake.