Initial System Start-Up
Be sure to press the RESET switch when using the unit for the first time, after changing the car battery, etc.
1Turn off the unit power.
2Press 
(OPEN) to open the front panel, then remove it.
3Press RESET with a ballpoint pen or similar pointed object.
RESET switch
Adjusting Volume
Turn the Rotary encoder until the desired sound is obtained.
Lowering Volume Quickly
Activating the Audio Mute function will instantly lower the volume level by 20 dB.
Press MUTE to activate the MUTE mode.
The audio level will decrease by about 20 dB.
Pressing MUTE again will bring the audio back to its previous level.
Setting Time
1Press TITLE repeatedly until the time is displayed. For details, see “Displaying the Text” (page 15)
2Press and hold TITLE for at least 2 seconds while the time is displayed.
The time indication will blink.
3Turn the Rotary encoder to adjust the hours while the time indication is blinking.
4When the hour has been adjusted, press MODE.
5Turn the Rotary encoder to adjust the minutes while the time indication is blinking.
The time is automatically set 5 seconds after the minute adjustment. The time can also be manually set by pressing
TITLE.
•To synchronize the clock to another clock/watch or radio time announcement, press and hold MODE for at least 2 seconds after setting the “hour.” Minutes will reset to 00. If the display shows over “30” minutes when you do this, the time will advance one hour.
•Controllable with Remote Control
This unit can be controlled with an optional Alpine remote control. For details, consult your Alpine dealer.
•Point the optional remote control transmitter at the remote control sensor
Remote control sensor