Alpine KTP-445U owner manual Specifications

SPECIFICATIONS

	Input Sensitivity
Crossover
	Dimensions
NOTE:
•	For product improvement, specifications and design are subject to change without notice.
ACCESSORIES
•	Mounting Bracket	2
•	Self-Tapping Screw (M4 x 12)	4
•	Cable Tie	2
•	Input Wire Harness	1
•	Output/Power Wire Harness	1

INSTALLATION

(Fig.

1

and

Fig. 2)

With this amplifier, there are two options for installation. Depending on which to .instructions A or B below.

is

best for

your

tarQet

location, refer

~CAUTION

+

Caution on connection terminals/parts

•Keep electrically conductive objects away from the unit'sterminals/parts (power terminals, fuses, speaker output terminals, RCA connectors, etc.). Doing so prevents a possible short circuit and damage to the unit.

A. Installation with mounting brackets

1. 2. 3. 4. 5. 6. 7. 8.

Remove the two bottom screws on each end panel. Use these screws to attach the included mounting brackets. Using the amplifier as a template, mark the four screw locations. Make sure there are no objects behind the surface that may become damaged during drilling. Drill the screw holes. Position the KTP-445U over the screw holes, and secure with four self-tapping screws. Position the unit over the screw holes you prepared earlier. Fasten the unit down with the four self-tapping screws (M4 x 12). Refer to Fig. 1.

B.

Installation with chassis mounting loops

1. 2.

Push each of the included cable ties Use the cable ties to securely attach

through the two mounting loops near each end on the the amplifier to the vehicle'sframe or chassis. Refer to

bottom panel. Fig. 2.

NOTE:
•	To securely connect the ground lead, use an already installed screw on the metal part ofthe vehicle
	(marked*). Be sure this is a good ground by checking continuity to the battery (-) terminal. As much
	connect all equipment to the same ground point. These procedures will help eliminate noise.

as possible