Settings/Adjustments
G.EQ CHANNEL
ENTER
5
P.EQ
Rotary encoder
6
Graphic equalizer adjustments
The graphic equalizer allows you to modify the sound using 31 bands each for the front (left and right), rear (left and right) and centre speakers. An additional 10 bands are available for the
subwoofer. This allows you to customize the7 sound to suit your taste.
8
1 Check that the defeat mode is off. (See page 28.)
2 Press the G.EQ button to set the graphic equalizer mode.
3 Press and hold the CHANNEL button for at least 2 seconds and select “L and R (LR)” or “L or R”.
L and R (LR) 
L or R
(factory default)
L and R (LR): Sets the same adjustment values for the left and right channels.
L or R: Different adjustment values can be set for the left and right channels.
4 Press the CHANNEL button to select the desired 9 channel, then press the ENTER button.
When “L and R (LR)” is selected:
*1
Front 
Rear 
Center Sub. W
When “L or R” is selected:
Front L Front R | Rear L Rear R |
*3 | *2 |
Sub. W | Center |
12-EN
*1 When centre is set to subwoofer, it is not displayed.
*2 When centre is set to subwoofer, it becomes Sub.W(L).
*3 When centre is set to subwoofer, it becomes Sub.W(R).
Turn the Rotary encoder to select the frequency, then press the ENTER button.
Adjustable frequencies
Front/Rear/Centre: 20Hz~20kHz (1/3 octave step)
Sub.W: 20Hz~160Hz (1/3 octave step)
Turn the Rotary encoder to adjust the level (± 9 dB in steps of 1 dB), then press the ENTER button.
3 1 – G . E Q F r o n t L
1 2 . 5 k H z | – 9 d B |
Repeat steps 5 and 6 to adjust other frequencies.
To adjust other channels, press the CHANNEL button to return to step 4.
*The difference in the sound when the defeat mode is turned off (adjusted graphic equalizer settings) and on (default values)
can be checked as follows:
1)While in the adjustment mode, press and hold the G.EQ button for at least 2 seconds.
2)Press the G.EQ button to switch the defeat mode on and off and listen to the difference in the sound.
3)To quit, select the desired setting, then press the ENTER button.
Note that if you press the ENTER button with the defeat mode turned on, the adjustments are reset to the defeat on status (the default values).
Once the adjustments are completed, press the G.EQ button.
NOTES
•When the speaker is set to the “OFF” mode, the graphic equalizer for that speaker is ineffective. Refer to “Setting the speakers” (page 4).
•Check the playable frequency ranges of the connected speakers before making the equalizer adjustments. If the speaker’s playable frequency range is 55 Hz to 30 kHz, for example, adjusting the 40 Hz or 20 Hz band has no effect. Additionally, you may overload and damage the speakers.
•After making the settings, we recommend storing them in the memory. For instructions, see page 28.
•When graphic EQ is adjusted, the adjustment for parametric EQ becomes ineffective.