Alpine PXA-H700 owner manual Convenient Functions, Navigation system voice guidance interruption

Press the SETUP button. The setup mode is set.

Turn the Rotary encoder to select the “NAVI MIX” mode, then press the ENTER button.

Press the SETUP button. The setup mode is set.

Turn the Rotary encoder to select the “PCM MODE”, then press the ENTER button.

Convenient Functions

6

ENTER

Press the SETUP button repeatedly to quit the setup mode.

NOTE

For connection with navigation, refer to the "Installation and Connections" (page 40).

SETUP

Rotary encoder

Navigation system voice guidance interruption

When the navigation system is connected, make the navigation system’s voice guidance messages to interrupt the PXA-H700, then output from the front speaker.

1

2

3 Turn the Rotary encoder to select “NAVI MIX ON” or “NAVI MIX OFF”, then press the ENTER button.

When ON is set, the navigation system's voice guidance messages interrupts the PXA-H700.

4 Turn the Rotary encoder to adjust the “MIX LEVEL” (volume level of navigation voice), then press the ENTER button.

The level can be adjusted from 1 to 15.

5 Turn the Rotary encoder and set “GUIDE CONT.” to “2”, then press the ENTER button. Do not use “1”.

Linear PCM setting

The output when playing discs recorded in linear PCM can be set to 2 or 3 channels.

1

2

3 Turn the Rotary encoder to select “2ch Output” or “3ch Output”, then press the ENTER button.

2ch Output: 2ch output (L/R)

3ch Output: 3ch output (L/R/CENTER)

4 Press the SETUP button repeatedly to quit the setup mode.

NOTE

This PCM mode is ineffective if the center speaker is set to “OFF” or “Sub.W” in the speaker setup settings.

26-EN