Automatic Adjustments
2) Connect the microphone to the
AUTO TCR
ENTER
Rotary encoder
Performing time correction automatically (Automated Time Correction)
Due to the particular conditions inside the vehicle, there is a major difference between the distances of the various speakers and the listening position. This function uses the included measurement microphone to automatically measure and analyze the distances between the speakers and the listening position and perform the optimum time correction.
1 Check that the defeat mode is off. (See page 28.)
2 Prepare the vehicle.
1)Park the vehicle in a quiet place.
2)Close the vehicle’s doors and windows.
3 Connect the microphone.
1)Fasten the included microphone at the center of the driver’s seat’s headrest facing upwards.
To microphone 
Microphone input jack
Belt, etc.
Base unit
To microphone input jack 
Microphone
4 Set the vehicle’s engine key to the ACC position.
•Vibrations could make it difficult to achieve the appropriate adjustment values, so turn the engine off.
•Noise could make it impossible for automatic measurements to be made, so make sure the air conditioner, heater and all other devices are turned off.
5 Press the AUTO TCR button.
6 Turn the Rotary encoder, select the tweeter setting, then press the ENTER button.
YES 
NO
The count down starts.
7 Once the count down starts, get out of the vehicle and shut the doors within 10 seconds.
AUTO TCR
10 sec .
t o s t a r t
With the automatic adjustment function, the operation described below is performed. Adjustments are completed in about 10 seconds.
Time correction.
“END” is displayed for about 15 seconds and the automatic adjustment is completed.