Alpine PXA-H700 owner manual Accessories, To prevent external noise from entering the audio system

Page 34

Installation and Connections

IMPORTANT

Accessories

Please record the serial number of your unit in the space provided below and keep it as a permanent record. The serial number plate is located on the bottom of the unit.

SERIAL NUMBER:

INSTALLATION DATE:

INSTALLATION TECHNICIAN:

PLACE OF PURCHASE:

To prevent external noise from entering the audio system.

Locate the unit and route the leads at least 10 cm away

 

from the car harness.

Keep the battery power leads as far away from other

 

leads as possible.

Connect the ground lead securely to a bare metal spot

Ai-NET cable

Display cable

 

 

 

 

 

 

 

 

 

 

 

Connection Cable Velcro fastener for mounting control unit or base unit

 

x 3

Pan head screw

Flat head screw

(M3 x 5)

(M5 x 8)

Microphone

Flanged self- tapping screw (M4 x 14)

x 4

Flush mount

(remove any paint, dirt or grease if necessary) of the

car chassis.

• If you add an optional noise suppressor, connect it as

far away from the unit as possible.

Your Alpine dealer carries various noise suppressors.

Contact them for further information.

• Your Alpine dealer knows best about noise prevention

measures so consult your dealer for further

information.

x 2

x 4

x 2

Self-tapping screw

Mounting unit

 

(M2.6 x 8)

 

 

x 4

1 set

32-EN

Image 34
Contents PXA-H700 Page Contents Still Hear Outside Noise While Driving Installation Location TemperatureMaintenance Setting the speakers Turning the power on and offAbout indicators Basic OperationAdjusting the input level Using with Ai-NET connectionsSwitching the input Adjusting the volume, balance, fader and subwooferAutomatic Adjustments YES noError Settings/Adjustments Concrete examplesCR / P H a S E L F 1 R R Settings/Adjustments Bass FocusExample of Steps 4 and 5 Setting Time difference TableGraphic equalizer adjustments Settings/AdjustmentsAdjustable frequencies Parametric equalizer adjustments Q P F r o n t L N D 3 5 k H z + 7 d B14-EN Over Over adjustment When L or R is selectedHints for adjusting the high range Hint for adjusting the subwooferHint for adjusting the low range MX settings 18-ENBass COMP. setting Using Dolby Surround Using the Pro Logic II modeAdjustment procedure for Dolby Surround Speaker setup Adjusting the speaker levelsAdjusting the level for individual speakers manual Mixing bass sound to the rear channelUsing Dolby Surround Adjusting the acoustic imageAchieving powerful high volume sound Adjusting the DVD levelConvenient Functions Linear PCM settingNavigation system voice guidance interruption Display settings MX mode setting Ai-NET connectionDefeat mode Storing settings in the memoryCalling out stored values Switching the display mode Switching the color of the illuminationInstallation and Connections Do not Splice Into Electrical CablesWiring Connections PrecautionsFuse Accessories To prevent external noise from entering the audio systemMounting the control unit InstallationInstallation using Velcro fastener Mounting other unitsFlush Mounting the control unit Mounting the base unit Using the Mounting Screws SuppliedVelcro Fastener Mounting Basic Connections Diagram Terminal specifications Connect toPlease observe the following when using Fiber Optic Cable Examples of system expansion38-EN PXA-H700 + Head Unit + Video Deck etc. + External Amplifier 40-EN Information TerminologyOthers Case of difficultyDimensions SpecificationsComponents Parts name Quantity Limited Warranty