Reverse Lead Orange/White, ACC power lead Red

1Parking brake lead (Yellow/Blue) Connect this lead to the parking brake lead powered when parking brake is pulled.

2Monitor control lead (White/Pink) Connect when upgrading with touch panel compatible products such as the IVA-D300 series.

34Remote control output lead (White/Brown)

To remote control input lead of ALPINE products used in the system.

5Reverse Lead (Orange/White)

Use only when a back-up camera is connected. Connect to the plus side of the car’s reverse lamp that lights when the transmission is shifted into reverse (R).

Switches the video picture to the back-up camera. This is linked with putting the car into reverse (R).

6ACC power lead (Red)

To ACC power lead powered when engine key position is ACC.

7Fuse (7.5A)

8Ground lead (Black)

Connect the lead to a good chassis ground on the vehicle. Make sure the connection is made to bare metal and is securely fastened using the sheet metal screw provided.

9Brake Lamp

pBrake Connector (Included)

qBrake Signal Lead

wBrake Switch e Headphone r Main monitor

t Connection cable y RGB cable

u To RGB output terminal i Made by Alpine navigation

o Audio input connectors (AUX 1)

Use these connectors to input the audio signals from a DVD player, video deck etc.

;Video input connector (AUX 1)

Use this connector to input the video signals from a DVD player, video deck etc.

aAudio input connectors (AUX 2)

Use these connectors to input the audio signals from a DVD player, video deck etc.

sVideo input connectors (AUX 2)

Use this connector to input the video signals from a DVD player, video deck etc.

dAudio output connectors

Use these connectors to output audio signals to a rear monitor, etc.

fVideo output connector

Use this connector to output video signals to a rear monitor, etc.

•When connecting to an IVA-D300 series or VPE- S431, use the “AUX IN 1” connector. When connecting a rear view camera, use the “AUX IN 2”.

To prevent external noise from entering the audio system.

•Locate the unit and route the leads at least 10 cm away from the car harness.

•Keep the battery power leads as far away from other leads as possible.

•Connect the ground lead securely to a bare metal spot (remove the coating if necessary) of the car chassis.

•If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various Alpine noise suppressors, contact them for further information.

•Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.

17-EN