Alpine TME-M710 owner manual 17-EN

Page 18

1Parking brake lead (Yellow/Blue) Connect this lead to the parking brake lead powered when parking brake is pulled.

2Dimmer lead (White/Blue)

This lead may be connected to the vehicle’s instrument cluster illumination lead. This will allow the backlighting of the unit to dim whenever the vehicle’s lights are turned on.

34Remote control output lead (White/Brown)

To remote control input lead of ALPINE products used in the system.

5Reverse Lead (Orange/White)

Use only when a back-up camera is connected. Connect to the plus side of the car’s reverse lamp that lights when the transmission is shifted into reverse (R).

Switches the video picture to the back-up camera. This is linked with putting the car into reverse (R).

6ACC power lead (Red)

To ACC power lead powered when engine key position is ACC.

7Fuse (7.5A)

8Ground lead (Black)

Connect the lead to a good chassis ground on the vehicle. Make sure the connection is made to bare metal and is securely fastened using the sheet metal screw provided.

9Parking Brake Lamp

pBrake Connector (Included)

qParking Brake Signal Lead

wParking Brake Switch

eHeadphone

rMain monitor

tConnection cable

If the cable is too short, use the extension cable (KWE-664N, sold separately).

yRGB cable

uTo RGB output terminal i Made by Alpine navigation

o Audio input connectors (AUX 1)

Use these connectors to input the audio signals from a DVD player, video deck etc.

;Video input connector (AUX 1)

Use this connector to input the video signals from a DVD player, video deck etc.

aAudio input connectors (AUX 2)

Use these connectors to input the audio signals from a DVD player, video deck etc.

sVideo input connectors (AUX 2)

Use this connector to input the video signals from a DVD player, video deck etc.

When connecting a rear view camera, use the “AUX IN 2”.

To prevent external noise from entering the audio system.

Locate the unit and route the leads at least 10 cm away from the car harness.

Keep the battery power leads as far away from other leads as possible.

Connect the ground lead securely to a bare metal spot (remove the coating if necessary) of the car chassis.

If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various Alpine noise suppressors, contact them for further information.

Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.

17-EN

Image 18
Contents TME-M710 Contents Still Hear Outside Noise While Driving Maintenance TemperatureFuse Replacement Installation LocationSwitching the Source Switching the Screen PositionAdjusting the Volume Basic OperationSwitching the display mode AdjustingMonitor Page Remote Control Sensor Base OperationInformation Case of DifficultySpecifications AV Interface UnitInstallation and Connections Do not Damage Pipe or Wiring When Drilling HolesPrecautions Installation Installing AV Interface UnitAttaching the monitor and stand for European customers only Main unit15-EN Connections Basic connection17-EN Page Appendix Français Italiano Name/Nom/Nombre/Nome Home Address/Privatanschrift/Adresse/Dirección/IndirizzoLuftport