Alpine TME-M710 owner manual Installation, Installing AV Interface Unit

Page 14

Installation

Installing AV Interface Unit

This Unit can be placed inside the trunk, on the kick panel of the front passenger's seat or underdash. However, to avoid unnecessary signal wiring, it is better to mount the Unit as close as possible to the Display.

DO NOT MOUNT THE INTERFACE UNIT IN LOCATIONS EXPOSED TO MOISTURE OR EXTREME HEAT (such as the engine compartment).

Velcro fastener Mounting:

1.Place a Velcro fastener onto the mounting surface. The rough side should be facing the unit.

2.Remove the backing to the adhesive on the Velcro strips. Press the unit onto the mounting location.

Attaching with screws

1.Place the unit on the location chosen for installa- tion.

2.Mark the screw locations using the unit as a template.

3.Drill a hole less than 3 mm in diameter.

WARNING

When you are drilling a hole in the car body, be careful not to damage pipes, tanks or electrical wiring etc.. It might cause an acci- dent or a fire.

4.Firmly attach the unit using 4 of the supplied self- tapping screws (M4 x 14).

Self-tapping screws (M4 x 14)

Velcro fastener (included)

13-EN

Image 14
Contents TME-M710 Contents Still Hear Outside Noise While Driving Maintenance TemperatureFuse Replacement Installation LocationSwitching the Source Switching the Screen PositionAdjusting the Volume Basic OperationSwitching the display mode AdjustingMonitor Page Remote Control Sensor Base OperationInformation Case of DifficultySpecifications AV Interface UnitInstallation and Connections Do not Damage Pipe or Wiring When Drilling HolesPrecautions Installation Installing AV Interface UnitAttaching the monitor and stand for European customers only Main unit15-EN Connections Basic connection17-EN Page Appendix Français Italiano Name/Nom/Nombre/Nome Home Address/Privatanschrift/Adresse/Dirección/IndirizzoLuftport