Setting Time, Listening to Radio, 10-EN | Alpine CDE-W235BT manual

Setting Time

1Press and hold AUDIO/SETUP (CDE-W235BT only) for at least 2 seconds or press SETUP (CDE-W233R only) to activate the SETUP selection mode.

2Turn the Rotary encoder to select GENERAL, and then press ENTER.

AUDIO GENERAL DISPLAY TUNER IPOD  BLUETOOTH*

* CDE-W235BT only.

3Turn the Rotary encoder to select the CLOCK ADJ mode, and then press ENTER.

The time indication will blink.

4Turn the Rotary encoder to adjust the hours while the time indication is blinking.

5When the hour has been adjusted, press ENTER.

6Turn the Rotary encoder to adjust the minutes while the time indication is blinking.

7Press and hold AUDIO/SETUP (CDE-W235BT only) for at least 2 seconds or press SETUP (CDE-W233R only) to return to normal mode.

Notes

•To synchronize the clock to another clock/watch or radio time announcement, press and hold ENTER for at least 2 seconds after setting the “hour”. Minutes will reset to “00”. If the display shows over “30” minutes when you do this, the time will advance one hour.

•Pressing will return to the previous mode.

•Pressing and holding for at least 2 seconds will return to normal mode.

•If no operation is performed for 60 seconds, the unit will return to normal mode automatically.

•Even when AUTO CLOCK is set to ON (refer to “Setting the Time to automatically Adjust” on page 13), the time can be adjusted manually. At the same time, if there is an adjustment request from RDS, the time will be adjusted automatically by RDS data.

Controllable with Remote Control

This unit can be controlled with an optional Alpine remote control. For details, consult your Alpine dealer. Point the optional remote control transmitter at the remote-control sensor.

Remote control sensor

Radio

Preset buttons	Preset buttons
(1 through 3)	(4 through 6)

	BAND
	
TUNE/A.ME		/ENTER
SOURCE/		Rotary encoder

Listening to Radio

1Press SOURCEto select TUNER mode.

2Press BAND repeatedly until the desired radio band is displayed.

F1 (FM1) F2 (FM2) F3 (FM3) MW LW F1 (FM1)

3Press TUNEA.ME to select the tuning mode.

DX SEEK (Distance mode) SEEK (Local mode) off (Manual mode) DX SEEK

Note

• The initial mode is Distance mode.

Distance mode:

Both strong and weak stations will be automatically tuned in (Automatic Seek Tuning).

Local mode:

Only strong stations will be automatically tuned in (Automatic Seek Tuning).

Manual mode:

The frequency is manually tuned in steps (Manual tuning).

4Press or to tune in the desired station. Holding down or will change the frequency continuously.