Alpine CDE-W233R, CDE-W235BT Turning Power On and Off, Source Selection, Initial System Start-Up

Getting Started

Turning Power On and Off

Press SOURCEto turn on the unit.

Note

• The unit can be turned on by pressing any other button except .

		Press and hold SOURCEfor at least 2 seconds to turn
		off the unit.
		Note
		• The first time power is turned on, the volume will start from level 12.
		Source Selection
		Press SOURCEto change the source.
		TUNER DISC USB AUDIO/IPOD*1 BT AUDIO*2 
SOURCE/	AUDIO/SETUP	AUXILIARY*3 TUNER
		*1 Only when the iPod/iPhone is connected.
/ENTER
Rotary encoder		*2	Only for CDE-W235BT.
			Only when BT AUDIO is set to ON. Refer to “Setting the
* The illustration is for CDE-W235BT.			BLUETOOTH Connection (BT IN)” on page 26.
		*3 Only when AUX SETUP is set to ON. Refer to “Setting the AUX
			SETUP Mode” on page 23.

SOURCE/	SETUP
	/ENTER

Rotary encoder

*The illustration is for CDE-W233R.

Initial System Start-Up

Be sure to press the RESET button when using the unit for the first time, after changing the car battery, etc.

1Turn off the unit power.

2Press RESET with a ballpoint pen or similar pointed object.

RESET button

Accessory List
•	Head Unit	1
•	Power Cable	1
•	Microphone (CDE-W235BT only)	1
•	Mounting Sleeve	1
•	Bracket Key	2
•	Face Plate	1
•	Rubber Cap	1
•	Hex Bolt	1
• Screw (M5 × 8)		4
•	Owner’s Manual	1 set

Adjusting Volume

Turn the Rotary encoder until the desired sound is obtained.

9-EN