CODES / WIRELESS REMOTE CONTROL
CD CHANGER ERROR CODES
If a problem should develop while operating the CD changer, the following error codes may appear on the display panel.
In any of the above situations, try ejecting the CD magazine from the changer and make sure the discs are clean, undamaged, and loaded correctly (refer to the Owner’s Manual of the CD changer).
If the suggested measures do not solve the problem, contact an approved warranty station near you for further assistance.
WIRELESS REMOTE CONTROL OPERATION
CD CHANGER ERROR
14
1POWER ON/OFF - See Main Unit 1.
2 MODE SELECTOR (MODE) - See Main Unit
bn.
3INFRARED SENDER - Emits infrared sig- nal to radio which is detected by the sen- sor.
4 VOLUME (VOL) CONTROL- See Main Unit
2.
5 SELECT BUTTON (SEL) - See Main Unit
3, 4, 5, 6, and 7.
6TUNE/SEEK CONTROL – See Main Unit
bm, except press to increase
frequency, and press to decrease frequency.
MANUAL SEEK TUNING – See Main
Unit bm ,except press and hold to
Seekupward, press and hold to Seek downward.
CD TRACK SELECT – See Main
Unit cr, except press to select
a higher track number, press to select a lower track number.
CD CUE/REVIEW – See Main Unit
cs, except press and hold for Cue Function, and press and hold for Review function.
7 AUDIO MUTE (MUTE) - See Main Unit
bs.
8 EQUALIZER (EQ) - See Main Unit
9.
14 of 20