Audiovox ACD95 manual Bp MONO/STEREO Selection M/S, Bq PRE-SET Scan PS / AUTO-STORE Tuning AS

OPERATING INSTRUCTIONS

8

LOC icon to disappear from the display panel, and the radio will stop at a wider range of signals, including weaker (more distant) stations.

bp MONO/STEREO SELECTION (M/S)

During FM radio operation, this button is used to select mono or stereo reception of the broad- cast signal. Under normal reception condi- tions, the unit should be left in the stereo mode

as indicated by the ST indication on the display panel when tuned to an FM stereo sig- nal. If the stereo signal is too noisy for com- fortable listening, press the M/S button to switch to monaural reception; the ST indi- cation will disappear from the display. To re- turn to stereo reception mode, press the but-

ton again so that the ST indication reap- pears on the display.

bq PRE-SET SCAN (PS) / AUTO-STORE TUNING (AS)

Press this button momentarily to scan the stations pre-set into the current AM band or FM band. The unit will stop at each pre-set station for 10 seconds before continuing to the next pre-set station (the pre-set station number on the display panel will flash during Pre-Set Scan operation). Press the button again momentarily to stop Pre-Set Scan operation and remain on the selected frequency.

Pressing and holding the button for longer than

2seconds will activate the Auto-Store (AS) Tuning feature which will automatically scan and enter up to 6 area stations into the pre-set memories on the band in use. If the radio is in the local mode (LOC displayed) the radio will scan and enter only the stronger, more local stations. If you have already set the pre-set memories to your favorite stations, activating the Auto-Store Tuning feature will erase those stations and enter the new ones. This feature

is most useful when traveling in a new area where you are not familiar with the local stations.

br STATION PRE-SET MEMORIES

To set any of the 6 pre-set memories in each band, use the following procedure:

1.Turn the radio on and select the desired band.

2.Select the first station to be pre-set using the MANU/SKIP or Auto-Store (AS) Controls.

3.Press the pre-set button to be set and continue to hold it in for approximately 2 seconds. The preset number (CH 1-6) will appear on the display panel, indicating that the station is now set into that pre-set memory position.The station can now be recalled at any time by pressing that button.

4.Repeat the above procedure for the remaining 5 pre-sets on that band and for the other 4 bands on the unit.

bs AUDIO MUTE (MUTE)

This button is used to mute the volume from the system. By pressing the button, a flashing volume indication will appear on the display panel and the volume will be muted. Press- ing the MUTE button again, or activating the Volume Control 2, LOUD button 8, or Equal- izer (EQ) button 9 will return the volume level to the setting in use before the Mute function was activated.

bt LIQUID CRYSTAL DISPLAY PANEL

The Liquid Crystal Display (LCD) panel displays the frequency, time, and activated functions.

128-6566

8 of 20