Audiovox P-57S manual Select Button SEL Display Call Display Priority Selector, Bass Control

3SELECT BUTTON (SEL) DISPLAY CALL

DISPLAY PRIORITY SELECTOR

This button is used to select the audio function (volume, bass, treble, balance, or fade) to be adjusted using the Level Control 2, as well as the indication (time, frequency, or radio pre-set number) shown on the display panel. A momentary press of the button will change the display from radio frequency to clock time. After 5 seconds, the display will automatically return to frequency if set to frequency display priority. If the unit has been set to time display priority, a momentary press of the button will change the display from time to frequency. After 5 seconds, it will change back to time display.

Additional momentary presses of the button will set the unit for bass adjustment (level number above “BASS” will flash on display panel), treble (level number above “TREBLE” will flash), balance (“bAL” on display), fader (“FAd”) or volume (level number). The display will automatically return to the normal indication 5 seconds after the last adjustment is made or when another function is activated.

This unit can be set so that either the clock time or radio fre- quency will normally appear on the display panel. Use the fol- lowing procedure to set the display priority:

CLOCK TIME PRIORITY: With radio frequency on the display panel, press and hold the Select button for approximately 2 seconds until clock time is shown. The display will now automatically return to time display 5 seconds after any other radio, or audio function display.

NOTE: Release the button as soon as the display changes from frequency to time (approximately 2 seconds). Holding the button in for too long will put the unit into time setting mode (flashing time display). See section on “Setting the Clock”.

FREQUENCY DISPLAY PRIORITY: With clock time showing on the display panel, press and hold the Select button for approximately 2 seconds until the frequency display is shown. The display will now automatically return to radio frequency 5 seconds after any other function is activated.

4BASS CONTROL

To adjust the bass level, first select the Bass mode by pressing the Select button 3 so that the level number above the “BASS” indication is flashing. Within 5 seconds of choosing the Bass mode, press the + or - side of the Level control 2 to adjust the bass response as desired. The bass level will be shown on the display panel from a minimum of -7 to a maximum of 7 (0 is flat response). The display will automatically return to the normal indication 5 seconds after the last adjustment or when another function is activated.

5TREBLE CONTROL

To adjust the treble level, first select the Treble mode by pressing the Select button 3 so that the level number above the “TREBLE” indication is flashing. Within 5 seconds of choosing the Treble mode, press the + or - side of the Level control 2 to

-2-