Setting the Clock, Frequency Step Switch

NOTES ON USE OF FRONT PANEL

1.Make sure the front panel is right-side-up when attaching it to the chassis as it cannot be attached when up-side down.

2.Do not press very hard on the front panel when attaching it to the chassis. No more than light to moderate pressure should be needed.

3.When attaching the front panel, make sure the right side is correctly engaged before pressing the left side to lock it into position.

4.When taking the front panel with you, please use the supplied carrying case to protect the panel from dirt and damage. Make sure there is no dust or dirt on the electrical terminals on the back of the panel as this could cause intermittent operation or other malfunctions.

DETACHING THE FRONT PANEL

Release Button

ATTACHING THE FRONT PANEL

Engage right side first

SETTING THE CLOCK

1.Turn the radio on so that the radio frequency or clock time is shown on the display panel.

2.Press and hold the Select button 3 approximately 4 seconds until the time display begins flashing.

3.While the time display is still flashing, press the Manual Up Tuning button ( + ) to adjust the hours and the Manual Down Tuning button ( – ) to adjust the minutes to the correct time.

4.When the correct time is shown on the display panel, press the Select button 3 again to return to normal display.

FREQUENCY STEP SWITCH

This unit is supplied pre-set at the factory for reception of North American radio stations (10 KHz. channel spacing on AM, 200 KHz. spacing on FM). Use in other areas of the world may require different channel spacing. A switch on the bottom of the chassis allows selection of 9 KHz. AM/50 KHz. FM channel spacing. With the 16-pin power connector un-plugged from the socket at the rear of the chassis, slide the switch to the appropriate position using a small screwdriver blade.

-6-