AM/FM Tuner Operation

VM9411

Tuner TFT Display

Default TFT Tuner Display

4	1	11	2	5	6
		P1
		ST	Loc
7		8	9	3	10

1.Current Radio Band Indicator

2.Radio Frequency Indicator

3.Clock

4.Stereo Broadcasting Indicator

5.Local Indicator

6.Preset Radio Stations

7.Front Zone Playing Mode

8.Rear Zone Playing Mode

9.User Defined Equalizer Level

10.Loud Setting Indicator

11.Current Preset Station Indicator

Alternate TFT Tuner Display

The VM9411 offers an alternate display for the AM / FM tuner interface that is less bright than the default tuner display and is more appropriate for night driving.

To activate this feature, open the TFT screen and then press and hold the DISP button (5) for more than one second. To deactivate, press and hold the DISP button again.

Tuner LCD Display

1.Current Radio Band Indicator

2.Radio Frequency Indicator

3.Current Preset Station Indicator

4.Stereo Broadcasting Indicator

5.Strong Local Signal Broadcasting Indicator

Switch to Radio Tuner source

Press the SRC button (15) on the front panel or remote control (8) to switch to the RADIO TUNER source. The Tuner TFT or LCD display appears.

Select FM/AM Band

Press the BAND button (14) on the front panel or the remote control (20) to change between the following bands: FM1, FM2, FM3, AM1, and AM2.

Seek Tuning

Press the >> button (19) on remote control or the > button on the joystick (17) to seek the next station higher.

Press the << button (17) on the remote control or the < button on the joystick (16) to seek the next station lower.

Manual Tuning

Press the /\ or V buttons (18, 19) on the joystick to increase or decrease the tuning frequency one step.

Using Preset Stations

Six numbered preset buttons store and recall stations for each band. All six stored stations (P1-P6) for the current band appear on the TFT screen.

Storing a Station

1.Select a band (if needed), then select a station.

2.Hold a preset button (8-13) for three seconds. The preset number appears in the LCD panel.

Recalling a Station

1.Select a band (if needed).

2.Press a preset button (8-13) to select the corresponding stored station.

Auto Store (AS)

To select six strong stations and store them in the current band:

1.Select a band (if needed).

2.Press the AS button (26) on the unit to activate the Auto Store function.

The new stations replace stations already stored in that band.

Local Radio Station Seeking (LOC)

When the Local function is on, only radio stations with a strong radio signal are played. To activate the Local function, press and hold the LO/DX button (6) on the front panel while the yellow volume bar IS NOT displayed. Press and hold LO/ DX again to turn Local off. When the Local function is active, the “LOC” indicator appears lit on the LCD or TFT screen.