Design Information
Dual Burner Outdoor Cooktop
Choosing the Location
•These cooktops are designed for outdoor use only. Do not locate the cooktop in a building, garage or other enclosed area.
•Ensure that fresh air ventilation is adequate.
•Consider exposure to wind and proximity to traffic paths.
•The minimum clearances to combustibles must be maintained at all times.
•Do not install an outdoor cooktop below overhead unprotected combustible construction.
•The installation must conform to local codes or in the absence of local codes, with the national fuel gas code, ANSI Z223.1a, latest edition.
Tools &
Materials
Required
(Not supplied)
• Phillips head screwdriver | For Natural Gas Installations: |
• Two adjustable pipe wrenchs | • Appropriate gas line to reach installation |
• 7/16" socket with extension | location |
• Level | • Pipe joint sealant, approved type and |
• Pliers | resistant to LP gases |
• Flat blade screwdriver (3/32" blade) | • Manual |
|
|
Step1
Remove the Packaging
•Open the box and remove packaging.
•Remove the cover and grate.
•Remove white plastic
•Open the hardware accessory carton and check contents.
10 - 24 x 3/4" Screws
Count 2
1/4 - 20 x 1/2" Bolts
Count 2
#10 Flat Washers
Count 2
10 - 24 x 3/8" Screws
Count 4
1/4" Flat Washers
Count 2
10 - 24 Lock Nuts
Count 6
1/4 - 20 Lock Nuts
Count 2
#10 x 1/4" Thick Round Spacers Count 2
Support Brackets
Count 2
LP MODELS
See Product to Determine Parts Used
3/8" Flare Tee and
Two 3/8" x 3/8" Flare Hoses
(On Models So Equipped)
3/8" NPT x 1/2"
Flare Fitting
NATURAL GAS MODELS
Regulator and
1/2" NPT Close Nipple
4